Operation
Recording
To end the recording, press the STOP button.
6
Recording now ends, and the unit is set to the
This function can be used only when the AJ-YA120AG
stop mode.
(optional accessory) has been installed.
<Note>
Check that the SERVO lamp remains lighted during
1recording. When it flashes or it is off, the playbackSet the cassette tapeOs erasure prevention tab
to recording enable, and insert the tape.
images will be disrupted.
2Press the STOP button to set the unit to the
STOP mode.
Pause/recording
(follow-on recording)
3Selecting the input video signals
Use menu item No.600 [VIDEO IN SEL] to select
the video input signals.1Press the PAUSE/STILL button while the
cassette tape is playing back.
1. Selecting the input audio signals
4
1) Connect the signals to be recorded.Press the REC button to set the unit to the
2
2) Use menu item No.700 [AUDIO IN SEL] toREC PAUSE mode.
select the audio input signals.The monitor display now switches to the E-E
<Note>screen.
When O1394� is selected as the menu itemWhen REC-P or ALL has been selected as the
No.600 [VIDEO IN SEL] setting, the audiomenu item No.154 [AUTO BACK] setting, the
signals are input from the DV connector (digitaltape will be rewound for several seconds from
video interface) regardless of the AUDIO INthe position where the PAUSE/STILL button was
SEL setting.pressed.
2. Adjusting the analog audio levels
OAdjust the levels of the audio input signals
when analog audio signals have beenPress the PAUSE/STILL button to start3
selected as the audio input signals.recording.
When the audio recording level controls areThe tape now runs as far as the position where
at their pushed-in positions, the audiothe PAUSE/STILL button was pressed in step 1,
signals are recorded at the proper levels.and recording commences.
<Note><Note>
When HD SDI signals or signals from the DVThe E-E screen is now displayed.
connector (digital video interface) are selected
as the audio input signals, it is not possible to
adjust their level.4Press the PAUSE/STILL button again to
temporarily stop the recording.
When REC-P or ALL has been selected as the
5While holding down the REC button, pressmenu item No.154 [AUTO BACK] setting, the
the PLAY button.tape will be rewound for several seconds from
The REC and PLAY lamps light, and recordingthe position where the PAUSE/STILL button was
commences.pressed, and then it will stop temporarily.
When ALL has been selected as the menu item
No.154 [AUTO BACK] setting, the tape is
rewound for several seconds from the positionFollow-on recording can be performed by5
where the REC and PLAY buttons were pressed.repeating steps 3and 4.
The tape will run up, and recording will start from
the position where the REC and PLAY buttons
were pressed so that the new recording will
follow on from the previous recording with no
disruptions in the continuity of the images.
16 |
ACEC
