Operation
Repeat playback
Setting the BEGIN and END pointsSetting the repeat playback mode
1Set the VTR to the menu mode.1Set the VTR to the menu mode.
(This is done by setting the LOCAL/MENU/(This is done by setting the LOCAL/MENU/
REMOTE switch to the MENU position).REMOTE switch to the MENU position).
2Select menu item No.161 [CTL (TC) BGN] or2Select menu item No.160 [MEMORY MODE],
No.162 [END], and press the DATA+ buttonand select the repeat playback mode.
(PAUSE/STILL button) or DATA- button (PLAY
button).
<Note>SettingOperation
Whether a setting is to be entered can be
selected by operating the DATA+ button andOFFNormal operation
DATA� button.
When the tape is fast forwarded or rewound, it
The � �:� �:� �:� � display appears when there isM-STOP
stops near the BEGIN point.
no setting. When repeat playback is performed
When the tape is played back to the END point, it
in this status, the BEGIN point serves as the tapeREPT1
is rewound to the BEGIN point where it stops.
start and END point as the tape end.
When the tape is played back to the END point, it
CONTis rewound to the BEGIN point and played back
again, and these operations are repeated.
3Use the COUNTER button to select TC or CTL.
<Note>
When the RESET button is pressed, the display
Set the LOCAL/MENU/REMOTE switch to the3
is reset to 00:00:00:00.
LOCAL or REMOTE position.
<Notes>
4Use the UP button (FF button) and DOWN
OThe image will deteriorate if the same tape is
button (STOP button) to select the digit to be
played back over and over again. Once a tape haschanged (the one that is flashing).
been played back for a hundred or so times,
The frame digits cannot be selected, and they
replace it with a new one.
always appear as O00.�
OThe image which is to be output when the tape is
returned to the BEGIN point in the repeat playback
5The DATA+ button (PAUSE/STILL button) andmode can be set using menu item No.163 [REPT
DATA� button (PLAY button) are used toMODE].
change the value displayed.When FREEZE is selected as the menu item
No.163 [REPT MODE] setting, the playback image
will not freeze properly if the tape end is set to
After performing the settings, press the SET6serve as the END point. Set the END point in a
button (REC button).section of the tape where images have been
The settings are now stored in the memory.recorded.
<Note>OIf the counter display mode (TC/CTL) established
If the MODE button (SEARCH) button is pressedusing the menu item No.161 [CTL (TC) BGN] or
without first pressing the SET button after theNo.162 [END] setting and the counter display mode
settings have been performed, the settings will(TC/CTL) in which repeat playback is to be
not be stored in the memory and the statusesperformed do not correspond, the REPEAT lamp
established prior to those settings will beflashes, and the repeat playback operation will not
restored.be performed.
Set the LOCAL/MENU/REMOTE switch to the
7
LOCAL or REMOTE position.
19 |
ACEC
