LSQT1093ENG.book 118 k 2376776
? e9a7 1
Others
Troubleshooting
a Unit operations
ProblemCheck points
This unit cannot be eIs the battery fully charged?
turned on.# Charge the battery using the AC adaptor. (l 31)
eThe battery protection circuit may have operated. Attach the battery
to the AC adaptor for 5 to 10 seconds. If the unit still cannot be
used, the battery is faulty.
eIs the LCD monitor opened or the viewfinder extended?
This unit is turned off eIf you do not use the unit for approximately 5 minutes, the power is
automatically.automatically turned off to conserve the battery charge. To resume
recording, turn the power back on. The power will not turn off
automatically when the power save function is set to [OFF]. (l 110)
eAre you connecting to a TV compatible with EZ Sync with a HDMI
cable?
# If you connect to a TV compatible with EZ Sync with a HDMI
cable and turn off the power on the TV with the remote control for
the TV, the power on this unit also turns off. If you are not using
EZ Sync, set [EZ Sync] to [OFF]. (l 96)
This unit does not stay eIs the battery low?
on long enough.# If the remaining battery power indication is flashing or the
message ?LOW BATTERY.? is displayed, the battery has run
down. Charge the battery. (l 31)
A clicking sound is heard eThis is the sound of the lens moving and is not a defect.
when the unit is shaken This sound will no longer be heard when the unit?s power is turned
about.on.
Battery runs down eIs the battery fully charged?
quickly.# Charge it with the AC adaptor. (l 31)
eAre you using the battery in an extremely cold place?
# The battery is affected by ambient temperature. In cold places,
the operating time of the battery becomes shorter.
eHas the battery worn out?
# The battery has a limited life. If the operating time is still too short
even after the battery is fully charged, the battery has worn out
and can no longer be used.
The minute display of the eThe remaining battery capacity indication is an approximation. If you
remaining battery power think the remaining battery capacity indication is not displayed
indication is not correctly, fully charge the battery, discharge it and then charge it
displayed correctly.again. (Even if this operation is performed, it may not be possible to
display the remaining battery capacity correctly if the battery was
used for a long period of time where the temperature was low or
high or if the battery was repeatedly charged.)
118
LSQT1093 |
ACEC
