Which buttons to press
on the remote controlWhat the screen will show
When N and Q are pressed together, the
installation menu will appear on the screen.
The symbols are just underneath the buttons.
Press the menu + button and �manual storeO will2
appear on the screen.
Press the menu + button again and �searchingO will
3
appear on the screen. A bar on the screen will
move to show the progress of tuning. When the
television finds a signal, �searchingO will go off the
screen, and the programme number will flash.
If the picture quality is poor, there may be a better
signal on another frequency, so start searching
again by pressing the menu + button again.
The best signals are usually in a group, one after
the other.
When your television has found a good signal,
4
decide which programme number you want it on,MANUAL STORE
for example programme 1 for BBC1. Make sure
you can recognise the test picture from any other
pieces of equipment if you have them connected.
While the programme number is flashing, press the
P+ or P- button to change the number. You canOt
use zero.
When you press N and Q together again, �storedO
5STORED2
will appear on the screen and the television will
store the television channel on the programme
number you have chosen.
Repeat steps 3 to 6 to store each programme.6
Press the menu button twice to leave the manual
7
store display.
3 |