Remote control keys
& Screen information/permanent no.ARadio / TV mode
To display / clear the program number,name (if it To switch the TV set to radio or TV mode (for
exists),time,audio mode and time remaining for the versions equipped with radio).
sleep feature.Press the key for 5 seconds to activate # Standby
permanent display of the number.This key is also Lets you place the TV set on standby.To turn on the
used to exit from the menu.TV,press P @@,b,0 to 9 (or �).
é Surround Sound (only availabel on certain versions)$ Teletext keys (p.8),VCR keys (p.11) and list of
To activate / deactivate the surround sound effect.radio stations Å¡ (p.5)
In stereo,this gives the impression that the % Sleep
speakers are further apart.For models equipped To select an automatic standby after a preset time
with Virtual Dolby Surround*,you can experience (from 0 to 240 minutes).
Dolby Surround Pro Logic sound effects.In mono,a & 16:9 modes (p.9)
stereo spatial effect is simulated.( Pre-set image
Ť VCR key **Used to access a series of stored settings:Rich,
Ź Pre-set soundNatural,Soft,Multimedia and return to Personal.
Used to access a series of stored settings:Speech,) Teletext keys (p.8)
Music,Theatre and return to Personal.~ Program selection
( MenuTo access the next or previous programme.The
To call up or exit the menus.number,(name) and sound mode are displayed for a
§ Cursor / Formatfew moments.
These 4 keys are used to navigate through the For some programs, the titleof the program will be
menus.The îI keys are used to enlarge or displayed at thebottom of the screen.
compress the picture vertically.+ Teletext keys (p.8)
e Volumeor VCR keys ** (p.11)
To adjust the sound level, Sound mode
! MuteUsed to force programmes in Stereo to Mono or,
To mute or restore the sound.for bilingual programs,to choose between Dual I or
ç Number keysDual II.For TV sets equipped for Nicam reception,
Direct access to the programmes.For a 2 digit depending on the programmes,you can force the
program,enter the 2nd digit before the dash Stereo Nicam sound to Mono or select between
disappears.Nicam Dual I,Nicam Dual II and Mono.
a Selection of EXT socketTheMono indication is red when in forced position.
Press several times to select EXT1,EXT2,S-VHS
and AV.* Dolby and the double-D symbolsL ear trademarks of the
Dolby atorLabories Licensing Corporation.
Manufactured under license of Dolby LaboratoriesLicensing
Corporation.
** VCR key
The remote control lets you control the main functions of the VCR.
Press and hold down the VCR key located on the side of the remote control,then press one of the keys to access
the VCR functions:b%+HIE?P@#09
The remote control is lecompatib withall VCRs using the RC5 standard.
Safety Information
Y Plug the TV into a 220V � 240V AC,50 Hz supply.
Y Disconnect mains plug when :
� the red light below the TV screen is flashing continuously.
� a bright white line is displayed across the screen.
� there is a lightning storm.
� the set is left unattended for a prolonged period of time.
Y Cleaning the TV screen.Never use abrasive cleaning agents.Use a slight damp chamois leather or soft cloth.
Y No naked flame sources,such as lighted candles,should be placed on top of the TV or in the vicinity.
Y Do not place your TV set under direct sunlight or heat.
Y Do not cover or block the TV as it could lead to overheating.
Y Leave at least 5 cm around each side of TV set to allow for proper ventilation.
Y Avoid placing your set (e.g.near the window) where it is likely to be exposed to rain or water.
Y Battery Usage CAUTION � To prevent battery leakage that may result in bodily injury,property damage,or damage to the
unit:
� Install all batteries correctly,with + and � aligned as marked on the unit.
� Do not mix batteries (old and new or carbon and alkaline,etc.).
� Remove batteries when the unit is not used for a long time.
Useful Tips
Y Do not leave your set on standby mode for a prolonged period of time.Switch off set to allow it to be
demagnetised.A demagnetised set supports good picture quality.
Y Do not shift or move the set around when it is switched on.Uneveness in colour in some parts of the screen may occur.
Y Never attempt to repair a defective TV yourself.Always consult a skilled service personnel.
3 |
ACEC
