The remote control keys
1 Screen information# Picture and sound settings
In digital mode,press once to display the informationAccesses a series of picture and sound settings.
nd
banner, a 2time to get more information on the The position Personal corresponds to the settings stored in
programme and a 3rd time to remove it (see p.4).the menus.
In analogue mode,this displays / removes the $ Standby
programme informations(number,name,sound To set the TV to standby mode.To switch the TV set
mode).Hold down for 5 seconds to permanently on again,press b,P @# or 09.
display the analogue programme number on the % Options menu (see p.9).
screen.& TV guide (see p.9).
2 Subtitle mode( Teletext features (p.14)
To activate/deactivate the subtitle modeand VCR/DVD keys (p.17).
3 Select EXT sockets (see p.16).) Digital Menu
4 Mode selectorTo display or exit from the digital menus (when TV is in
To activate the remote control in VCR or DVD digital mode).
mode (see p.17).~ Analogue or Digital mode
5 TV MenuTo switch the television between analogue and digital
To display or exit from the analogues menusmode.
6 Select+ Cursor
In digital mode this displays / clears the programme These 4 keys are used to move within the menus or to
list.Use the îI keys to select a programme anddirectly access the 16:9 screen formats (p 15).
uto display it., Programme selection
7 VolumeTo access the next or previous programme (or page in
To adjust the sound leveldigital menus).
8 Mute- Sound mode
To disable or enable the sound.To switch from Stereo to Mono or to choose
9 16:9 formats (p.15)between different languages (Dual I,Dual II,...).
! Previous programmeWhen the sound mode is switched to Mono,the indication is
To access the previously viewed programme.displayed in red.
Numerical keys. Surround sound
11For direct access to programmes.For a 2 (3) digit To activate / deactivate the surround sound effect.
programme number,the 2nd (3rd)digit must be In stereo,this gives the impression that the
entered before the dash disappears.The number,thespeakers are further apart.In mono,a stereo spatial
name (and the sound mode,in analogue mode) are effect is simulated.
displayed for a few seconds.
The Mono indication is red when in forced position.
Digital or Analogue channels ?
To receive TV channels, your television is equipped with 2 tuners. One is for digital channels, the other
is for analogue channels. Use the v key of the remote control to switch the TV between analogue
and digital mode.Then use the P @# or 09 keys to select channels.
Safety Information
Y Plug the TV into a 220V � 240V AC, 50 Hz supply.
Y Disconnect mains plug when :
� the red light below the TV screen is flashing continuously.
� a bright white line is displayed across the screen.
� there is a lightning storm.
� the set is left unattended for a prolonged period of time.
Y Cleaning the TV screen. Never use abrasive cleaning agents. Use a slight damp chamois leather or soft cloth.
Y No naked flame sources, such as lighted candles, should be placed on top of the TV or in the vicinity.
Y Do not place your TV set under direct sunlight or heat.
Y Do not cover or block the TV as it could lead to overheating.
Y Leave at least 5 cm around each side of TV set to allow for proper ventilation.
Y Avoid placing your set (e.g. near the window) where it is likely to be exposed to rain or water.
Y Battery Usage CAUTION � To prevent battery leakage that may result in bodily injury, property damage, or damage to
the unit:
� Install all batteries correctly, with + and � aligned as marked on the unit.
� Do not mix batteries (old and new or carbon and alkaline, etc.).
� Remove batteries when the unit is not used for a long time.
Useful Tips
Y Do not leave your set on standby mode for a prolonged
period of time. Switch off set to allow it to be demagnetised. A demagnetised set supports good picture quality.
Y Do not shift or move the set around when it is switched on.Uneveness in colour in some parts of the screen may occur.
Y Never attempt to repair a defective TV yourself. Always consult a skilled service personnel.
3 |
ACEC
