3104 305 4720.5.gb 26-05-1999 14:13 Pagina 17
To select connected equipment
If the TV is connected to a video recorder with the EasyLink function, in some cases
the TV will be switched on, even when the TV was in standby. (E.g. playback tape,...)
This is not possible when Child Lock On is selected.
Equipment connected with an aerial cable only :
YSelect the programme number under which you have stored the test signal
with the digit keys.
uu XjiEquipment connected to a euroconnector or to the right side of
hdfUthe TV
yo
Å¢Ss
YPress the ukey repeatedly to select EXT1, EXT2or FRONT, according to
where you connected your equipment at the back or the right side of your TV.
B
o
p1Remark : Most equipment (decoder, video recorder) carries this switching itself.
I
MENU
¨OK�-+VDo you want to watch TV channels again ?
�
YEnter the programme number of the TV channel which you want to watch with
the digit keys.
u XjiVideo recorder keys
fdhU
yoMost of the video equipment from our range of products can be operated
sŢ
with the remote control of the TV.
BB
Press simultaneously on the VCR key and:o
VCRp1
I
1 kfor play,
MENU
¨ kfor record,
1
1OK�-+V
�n kfor rewind,
¨
¨0-+P�
 kfor fast forward,
-+a kfor stop,n
n123
P
Â
 456F kfor programming (on certain models),
a
a789�for selecting 1- or 2- digit programme numbers from the
video recorder tuner,
FFb0q
Pfor fast programme selection from the video recorder tuner,
a
aa3
SMART CONTROLS0to 9to select a programme number from your video recorder
¨Mb
¨
tuner,
Bto switch the video recorder to standby
These keys function with video recorders which use the RC5 signalling standard.
If your video recorder has the EasyLink function the aO and ¨M keys for
record and stop can be operated in the TV mode.
17 |
ACEC
