2375.1 en 16-07-2004 16:07 Pagina 3
Use of the remote control RC4333
Note:For most keys pressing a key once will activate the function.Pressing a second time will de-activate it.
Remark:in VGA mode only some keys are valid.
VCR DVD TV SAT AMPB Standby
Press the SELECT key repeatedlyPress to switch the TV on or off.
to select one of the system modes
in which the remote control can be
used. If no action is being
b Teletext On/Mix/Off see p.12
undertaken within 2 seconds, theB
remote control returns to TV mode.Colour keys, see Teletext, p. 12.
After an action in the selected
system mode the remote controlOKPress this key
VCR DVD TV SAT AMP
will remain in this mode for 60- to activate your choice, when in
seconds and will then return to TVthe menus;
mode.vSELECT?- to display the channel list.
?O?A
v Select your peripheralsTVPCHDMENUMain menu on/off see p.9
See p. 8.
?Interrupt the sound or restore it.
ob
?PProgramme selection
To move up or down a programme.
A
The number, (the name) and the
Audio and Video equipment keys.OK??
sound modes are displayed for a few
seconds.
TV / PC / HD
?For some TV programmes the title of
Press one of these keys to switch
the programme appears at the bottom
the television between TV or PCPIPMENU
of the screen.
mode (p. 13) or to select your
connected Digital High Definition
++0/9 Digit keys
device.
Press HD once for HD-A (YPbPr);V?PTo select a TV channel.
twice for HD-D (HDMI).For a two digit programme number,
--
enter the second digit before the
PIP(Picture in Picture) On/Offdash disappears.To switch
See p. 11.immediately to a selected one digit123
TV channel, keep the digit key
VTo adjust the volume.pressed a bit longer.
456
i On Screen information0 Previous TV channel
789
To display/remove the programmePress to display the previously
number, the name (if it exists), theselected TV channel.
time, the sound mode and the timei00
remaining on the timer.:gTeletext keys,see p.12.
SLEEP:g
Hold down for 5 seconds to
DXhq
permanently display the programmeX Sound mode
number on the screen.The volumeTo switch from Stereo or NicamSMARTSMART
level and the smart controlMaStereo to Mono, or to choose
adjustments are then displayed eachbetween Dual Y or Dual Z in case
time they are used.of bilingual transmission.
When the sound mode is Mono,the
D Sleeptimerindication is displayed in red.
To select the length of time before
the set automatically switches toh Active control On/Off/On with
standby (from 0 to 240 minutes).Sensor
Optimizes the quality of the picture
according to the quality or
reception.
3 |
ACEC
