315 2114.1 US 13-07-2001 13:43 Pagina 26
Setting the remote control to work accessory devices
Your remote control is set to work your TV and many infrared remote (IR) control
VCRs, Cable TV Converter Boxes, DVD players, Satellite Receivers, etc.
o
Press the VCR or ACC button according to the accessory device you want to
O!A
VCR
operate with this remote control.
TVVCRACCACC
ACTIVEIf the function buttons on the remote control also work the selected
SWAPPIP CHCONTROLFREEZE
DNUPeaccessory device, then the remote is ready and no further steps are needed.
SOUNDPICTURE
MENU/If the functions buttons do not work the selected accessory device
STATUS/MENU/SELECT
EXITSELECTAccording to the device(s) you own, you may make your remote control ready
for them by a direct entry code. Proceed as following.
MUTE
VOL?CH
&Look up a three-digit remote control number for your brand of devices.
See pages 27-28.
132
If more than one number is listed, you may have to try more than one code in
465
order to locate your deviceOs remote code.
SURF
789
TV/VCRéPress and hold the proper device button VCRor ACCand press
A/CH0SURFsimultaneously the MENU/SELECT button, then release.
POSITIONPIP
Enter,within 30 seconds,the three-digit remote code number for your desired
l
SOUNDPICTUREdevice.The remote is now ready to send commands to the unit.
Note:If no code or an incomplete code is entered within 30 seconds,the backlight
and selected mode button will turn off and give a long blink before returning to
the previous programmed code.
Point the remote at the device.
Press the POWER button on the remote to turn the unit on.
Remember:If this doesnOt work the first time,repeat the steps using the same
remote code number.After second try and the remote does not operate your
device,see if there is another four-digit code number listed for your device.
Repeat the steps above using the new number.
If,after repeated attempts,the remote does not work your device,try the Auto
Search method following.
Auto Search method
&Turn on the desired device by pressing the POWERbutton on the device you
are attempting to program.
éPress and hold the proper mode button VCRor ACCand press
simultaneously the SURF button, then release.
The device will begin to change channels after the remote identifies the
correct code.
When the channels start to change,release the VCRand SURF buttons.
The remote should be ready to operate the device
Note:If any other button is pressed during Auto Search,the search will be
ended.The remote keeps its previous code.
For devices DVD and CD,insert a disc and press PLAY on the device.
The remote control will send the command next track.
Switch AV receivers to TUNER function.
This method can take up to two minutes to perform.
DonOt let the device change more than five channels after the remote identifies
the code.
If no channel change happens within two minutes, repeat the steps mentioned
above. Should a channel change still not occur, the remote will not work the
desired device.
26Working with accessory devices |