Trouble Shooting Tips
SymptomsItems to Check and Actions to follow
Ghost or double " This may be caused by obstruction to the antenna due to high rise buildings or hills.
images Using a highly directional antenna may improve the picture.
No power" Check that the TVs AC power cord is plugged into the mains socket.
" Unplug the television, wait for 60 seconds. Then re-inser t plug into the mains socket
and turn on the television again.
No picture" Check antenna connections at the bottom of the TV to see if they are properly connected to the TV.
" Possible broadcast station trouble. Try another channel.
" Adjust the contrast and brightness settings. Try another auto picture setting.
" Check the Closed Captions control. Some TEXT modes could block the screen.
" Check if you selected the correct AV source.
No picture and powe" Yr our TV has a protective mode in case there is too much h eat build-up. Check the
switched on clearance around the vents of the device to be certain th ere are no blocking walls or
cabinets which would limit the air flow.
Picture posit ion When displaying a High Definition signal from the YPbPr inputs or HDM I input, if necessary, you can
adjustmentadjust the picture position to the center of the screen with the cursor left/right or up/down buttons on
the remote control. This may be needed due to slight differences in output signals from different brands
and types of HD sources b oxes.
Notes: Most High Definition receiver boxes also have picture -positioning controls in their menu
systems. If the TV cursor controls run out of range before t he picture is correctly positoned, the
receiver box controls will need to be adjusted.
No photo, music or " Check if the source complies with a supported code.
video play or in poor
quality only
No sound" Increase the VOLUME.
" Check that the TV is not muted, press the MUTE button on the remote control.
" When no signal is detected, the TV automatically switches o ff the sound. This is proper
operation and does not indicate a malfunction.
Good sound but poor " Adjust the contrast, color, tint and brightness setting. Try another auto picture setting.
color or no picture
Snowish picture and " Check the antenna connection.
noise
Television n ot " Check whether the batteries are working. Replace if necessary.
responding t o " Clean the remote control sensor lens on the monitor.
remote control" Operating range between TV and the remote control should not be more than approximately twenty feet.
" You can still use the buttons on the right side of your TV.
" Check if the remote control is in the correct mode.
Control of accessor" Ty he infrared signals of the screen may influence the reception sensib ility of other peripherals Solution:
devices replace the batteries of the remote control of other devices. E.g. kee p away a wireless headphone from
within a radius of approximately four feet.
The software will nPoot ssibly the operating syste m is wrong.
installGo to www.usasupport.magnavox.com to see which operating systems are supported.
StandbyYour TV consumes energy less than 1w in th e standby mode.
Energy consumption contributes to air and water pollution.
After imprope r If your TV has been shutdown in an improper way (e.g. power drop, power cord plug out), starting up the
shutdownTV again will take a longer time than usual.
MiscellaneousSee Extras, Specifications on this users manual.
33 |