Adjusting the surround speakers
To use the surround speakers, you have first toloudspeaker (channel 1 has been selected as
proceed to the folowing adjustments :the factory default). If you should get
Remark :theses menus are only available wheninterferences from external RF equipment
surround speakers are connected to the set.(such a wireless headphone, mobile phone, ...),
& Switch on the television.it may be necessary to shift to another
Ž Press the H key.channel. In practice, only 2 or 3 channels are
O Select SOUND (J) and press L.available because a step of at least 2 channels
� Select CORDLESS (J) (hidden at the bottomare necessary to have enough separation.
of the screen) and press L.The menu ap p e a r s :Always be shure that the active speaker and the
cordless setting are switched to the same channel.
SOUNDOtherwise no sound or only distorted sound will be
Y PICTUREheard.
Y SOUNDY STORESURROUND
Y FEATURES
Y INSTALLY AVLAUDIO CHANNELŹ Press H to go back to the SOUND menu and
Y CORDLESS
select DELAY (hidden at the bottom of the
Y DELAY
screen).You can adjust, if you wish, the delay of
the surround effect (31 is the default value).
! Once the necessary adjustments have been
( Set SURRO U N D to ON to activate the soundmade, select the option STORE and press L
RF transmission.to store them.
¤ Select AUDIO CHANNEL (J) and select the! To exit from the menus, press R.
same channel as you selected on the active
Glossary
EasyLink:NICAM sound:
Digital link between the set and the videoProcess by which digital sound can be
recorder which allows a direct transfer oftransmitted.
certain information such as channel setting.
System:
RGB Signals:Television pictures are not broadcast in the
These are 3 Red, Green and Blue videosame way in all countries.There are different
signals which directly drive the red, green andstandards: BG, DK, I, and L LO.The SYSTEM
blue emitters in the cathode ray tube. Usingsetting (p. 6) is used to select these different
these signals provides better picture quality.standards.This is not to be confused with
PAL or SECAM colour coding. Pal is used in
S-VHS Signals:
the majority of European countries, Secam in
These are 2 separate Y/C video signals from
France, the CIS and the majority of African
the S-VHS and Hi-8 recording standards.
countries.The United States and Japan use a
The luminance signals Y (black and white) and
different system called NTSC.The inputs
chrominance signals C (colour) are recorded
EXT1 and EXT2 are used to read NTSC
separately on the tape.
coded recordings.
This provides better picture quality than with
standard video (VHS and 8 mm) where the16:9:
Y/C signals are combined to provide onlyRefers to the ration between the length and
one video signal.height of the screen.Wide screen televisions
have a ration of 16/9, conventional screen TV
sets have a ration of 4/3.
17 |
ACEC
