Using NexTView(only available on certain versions)
& First, select a channel offering the NexTView service.Ask your local
dealer for a list of the channels which offer this service.
The NexTView mode also works on external sockets.
If you have an analogue satellite receiver,other channels also offer this
service (consult your dealer).
`.
é Press O key at the top of the remote control.
-OÅ¡|
TVThe message OSEARCH NEXTVIEW INFO� is displayed at the bottom
VCR123of the screen.After a few moments, a NexTView page is displayed on
DVD
screen.
456
If the service is not available on this channel,after approximately 1 minute,
789
SMARTSMARTthe message ONOT AVAILABLE�is displayed for several seconds.Try selecting
-0a
another channel.
MENUŤ Use J and I keys to consult the programmes available.
The active zone is indicated in yellow.When a summary or a comment
is available, it appears at the bottom of the screen.
Ź You have the choice of two NexTView display modes. Press the green
Ž[Pbutton on the remote control to select SINGLE or MULTI mode.
For each change of mode,the message OPLEASE WAIT�appears at the
?cEA
bottom of the screen and the search may take up to 1 minute.
OK%+SINGLE mode:
¤?�
Only programmes from the channels which transmit NexTView are
OSD
&?displayed.You have access to all programmes for the day.
AMULTI mode:
u�
The programmes from several channels are displayed.
Use the keys @ P# to change channel.
Note:It is the NexTView service provider that determines the channels which
are presented (generally national channels).
In multi mode,if there are many channels,the display is limited to 20 lines
(approx.4 pages).
( The colored keys on the remote control provide access to other
functions:
Direct programming of the recording:
If your video recorder has a NexTViewLink function (and is
connected to the EXT2 socket), you can programme a recording. Use
the J and I keys to select the programme that you want to record
and press the red key to confirm.Your recorder is programmed.
You can only record one programme at once.
Display function:
The yellow key allows you to directly display the programme which is
selected using the JI keys.
Note:if you are asked to enter a number,you must enter the corresponding
programme number (the first time only).Caution,to be able to correct an
error,the channel must be stored again using the manual Tuning menu (p.6).
§ To exit: press key O.
11 |
ACEC
