Esp Zappa 1333.3 GB only 1/9/06 2:52 PM Page 4
Quick installation
The first time you switch on the television, aThis operation takes a few minutes.The display
menu appears on the screen and the tuningshows the progress of the search and the
starts automatically.number of programs found.
At the end of the search, the menu disappears.
Main Y
To exit or interrupt the search,press H.If no
Install Y
program is found,consult the possible solutions p.12.
Auto Store Y Searching
Please Wait& If the transmitter or cable network sends the
Prog. found 3
automatic sort signal, the programs will be
525,25 MHz
numbered correctly. In this case, the
installation is complete.
é If this is not the case, you need to use the
Sort menu to number the programs correctly.
If the menu is not displayed,press and hold down
Some transmitters or cable networks broadcast
the Ž- and Ž+ keys on the TV set for 5
their own sort parameters (region,language,etc.).
seconds to start the tuning (or MENU key
In this case,indicate your choice using the îI
depending on versions).
keys and validate with ?.
All the available TV programs will be stored.
Program sort
& Press key H.The Main menu is displayed oné With the cursor, select the Install menu
the screen.followed by the Sort menu.
Main Y Ť Select the programme you want to move using
Install Y the îI keys and press ?.
Language Y Ź Then use the îI keys to select the new
Country Y 00
number and validate with E.
Auto Store Y 01 BBC1
Manuel Store Y 02 BBC2( Repeat steps Ť and Ź for each program you
Sort Y03AANGLI
wish to renumber.
Program Y 04 CH4
05 CH5
Name Y § To quit the menus, press d.
Program name
If required, you can give a name to theŹ Use the E? keys to move around the
programmes and external connectors.
name display area (5 characters) and the
Note:on installation,the programs are named
îIkeys to select the characters.
automatically when an identification signal is sent.
( When the name has been entered, use the H
& Press the H key.
key to exit.The name is stored.
é With the cursor, select the Install menu, then
§ Repeat steps Ť to ( for each programme
Name.
you wish to name.
Ť Use the @P# keys to select the
e To quit the menus, press d.
programme to name or rename.
4 |
ACEC
