2059.1 gb /05 15-05-2000 15:33 Pagina 27
Connect Extra loudspeakers / Amplifier
REAR multimedia loudspeakers
You can enjoy Dolby Pro Logic Surround sound by connecting two rear
loudspeakers to be connected or to the connector clips (if provided) or to
the Dolby Surround output S at the back of your TV.
To the connector clipsorTo the output S
(if provided)
AUDIO
S
RL
REAR
&Connect two Surround Sound rear loudspeakers (min.16 &)&Connect two rear loudspeakers with built in amplifiers (or
to the connector clips at the back of the TV. Always connectan audio amplifier with rear loudspeakers).
both Surround Sound loudspeakers: the left rear loudspeaker
at REAR L; the right rear loudspeaker at REAR R.Connect the audio cables to the rear loudspeakers and to
the Dolby surround output S at the back of your TV as
Push the connector clip down and insert the end of the wire intoshown above.
the opening:the positive wire (the one with the black line) to theThere is only one cinch output for both speakers. Use a
red loudspeaker connection;the negative wire to the blackmono to stereo adaptor.
loudspeaker connection.Do not insert the wires too far.Note:Switch off the TV and the rear loudspeakers before
The Surround Sound loudspeakers should always be locatedconnecting them.
behind or to either side of the listener.If preferred you can also
hang the loudspeakers on the wall.éSelect Rear speakers Yesin the Setup menu.See p.7.
See Surround settings, p. 14 for the available Surround
éSelect Rear speakers Yesin the Setup menu.See p.7.modes.
See Surround settings, p. 14 for the available SurroundRear Surround Sound loudspeakers should always be located
modes.behind or to either side of the listener at about 1 m above
Rear Surround Sound loudspeakers should always be locatedthe seated listenerOs head.
behind or to either side of the listener at about 1 m above Adjust the volume of the rear loudspeakers.
the seated listenerOs head.You can use - the Test tone function in the Surround settings
Adjust the volume of the rear loudspeakers.menu, see p. 13, as a reference to set the volume level of the
You can use the Test tone function in the Surround settingsseparate loudspeakers.
menu, see p. 13, as a reference to set the volume level of theNote:Once you have adjusted the volume of the rear
separate loudspeakers.loudspeakers,do not change it while watching TV,the volume
Note:Once you have adjusted the volume of the rear level of all the speakers is changed with the volume control
loudspeakers,do not change it while watching TV,the volume of the TV.
level of all the speakers is changed with the volume control of
the TV.
Connect Peripheral Equipment27 |
ACEC
