2271.1 en 23-10-2003 15:52 Pagina 1
Preparation
Unpacking and wall mounting instructions
For the unpacking instructions follow the illustrated steps printed on the
packaging (outside and inside). For the wall mounting instructions follow the
illustrated steps Ź to § printed on the separate template.
Make sure that the wall mount is being fixed securely enough so that it meets
safety standards.The weight of the monitor (excl. packaging) is about 36 kg.
Note:Stands are optional accessories.Consult your dealer.
To prevent any unsafe situations, no naked flame sources, such as lighted
min.candles, should be placed on or in the vicinity.Avoid heat, direct sunlight and
1 mexposure to rain or water.
The equipment shall not be exposed to dripping or splashing and no objects
filled with liquids, such as vases, shall be placed on it.
Connect your computer
Directly to the monitor
&Connect one end of a VGA cable to the video card of the computer and the
other end to the VGA 1 connector at the rear side of the monitor. Fix the
connectors firmly with the screws on the plug.
RC OUT
VGA 1VGA 2éIn case of a multimedia computer,connect the audio cable to the audio
~ MAINSRS232outputs of your multimedia computer and to the audio inputs of your external
amplifier.
VGA 2:The video connector for VGA2 can be programmed to become an input or an
output via the Setup menu,see p.6.The function of being input or output is
determined by the used mode.If the monitor is used in video mode,the VGA2
connector is VGA output.If the monitor is used in monitor mode,the connector is VGA
input or output.
To an electronic receiver box
See the handbook of the receiver box.
&Connect one end of a VGA cable to the video card of the computer and the
other end to the PC/MAC IN connector at the rear side of the receiver box.
Fix the connectors firmly with the screws on the plug.
In case of a Multimedia computer,connect the audio cable to the audio
outputs of your Multimedia computer and to the AUDIO IN R and L inputs of
the receiver box. For sound reproduction, connect your external amplifier to
the electronic receiver box.
Note:Only use the VGA cable supplied with the monitor.
Daisy chaining
The Loop Through facility makes it possible to make a daisy chain with a
second monitor.
Connect one end of another VGA cable to the VGA 2 connector at the rear
side of the monitor and the other end to the VGA 1 connector of a second
monitor.
The RC out jack next to the VGA 2 connector makes it possible to daisy chain remote
control signals to other equipment.This output cannot be used to daisy chain a
second monitor.
Serial I/O port RS232
The RS232 connector is only to be used with the monitor as stand alone.
This connector allows you to control the monitor via your PC (as a
replacement of the remote control).
Note:This connector can also be used for dealer service tools.
1 |
ACEC
