TV menu-Installation
Select the menu language
Installation7Language31Press the MENU button on the remote control.
LanguageEnglish2Use the cursor down to select Installation in the Settings menu.
AutoprogramFrançais3Use the cursor right to enter the Installation menu.
SourceEspanol
4Select Language and enter the list of available languages with the
Clock
cursor right.
Weak channel installation
Current software info5Select your preferred language with the cursor up/down and press
Reset AV settingsthe OK button to conA rm your selection.
6Proceed with the Installation menu.
Info
Store TV channels
1Select Autoprogram in the Installation menu.
2Use the cursor right to enter the Autoprogram menu.
3Select Cable or Antenna in the Installation mode.
Installation7Autoprogram2
LanguageAntennaWhen Antenna is selected, the TV will detect antenna
AutoprogramCablesignals and will search for antenna TV (NTSC and ATSC) channels
Sourceavailable in your local area.
Clock
Autoprogram2AntennaWhen Cable is selected, the TV will detect cable company
Weak channel installationWeak channel installation
Antenna
supplied signals and will search for cable TV (NTSC, ATSC, QAM
Current software infoCurrent software info
CableStart now
Reset AV settingsmodulated) channels available in your area.
Make sure that registration with your cable TV provider and
Info
connection of equipment are completed.
4Select Start now with the cursor right key.
5Press the OK button.
6Press the green bSuttatrotn ? to start Autoprogramming. The
Info
menu screen disappears and the progress of Autoprogramming
is displayed. The progress bar indicates the number of analog and
digital TV channels found.
Television InstallationAuto programming may take up to 20 minutes to complete. Digital
channels will take longer than Analog to nd and program. Please
You can now start automatic installation. This
procedure can take more than half an hour.wait until you see the Auto Programming complete message. The
TV will then switch automatically to the rst channel found.
Note: All channels must be unlocked in order to autoprogram. If
requested, enter your PIN code to unlock all channels. (p. 25)
PreviousStart
Notes:
When you have locked TV channels before initiating Autoprogram, a message appears asking to enter your PIN code in
order to complete Autoprogramming.
ATSC channel information is updated automatically when the TV is in standby after 3 minutes and every 3 hours thereafter.
When channel update is interrupted, the new updated channel information is retained along with the old un-updated
channel information.
Channel information about an ATSC channel is updated only for the ATSC channel currently tuned.
If an NTSC channel is tuned, then in Background Autoprogramming the TV will scan all the possible ATSC frequencies
and update information.
Weak channel installation allows you to manually tune weak ATSC channels in order to adjust the antenna and thus
optimize signal quality for that channel. (See Installation menu, Weak channel installation, p. 13.)
Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
If Antenna/cable signal is interrupted more than ten minutes, TV will go into off mode. You are requested to press Power button
o r CH + / - button to turn on the TV.
12 |
ACEC
