Programming the Remote Control
Your TV remote control can operate accesso-
ry devices such as cable boxes, VCRs, DVD
players, satellite receivers, and amplifiers.
Normally, the remote is in TV mode. You
must press the Select button to switch the
remote to one of the accessory modesNCBL,
VCR, DVD, SAT, or AMP. AMP
It is likely you will need to program you
remote, but, before you do, try this test:GUIDE
POWERSELECTPOWER
HIGH DEFINITIONINFO
Y Press the Select button repeatedly until the
mode you desire lights up. When the light
SAT
begins blinking, point the remote toward
the accessory device, then press theDVD619 DVD/CD PLAYEROPEN/CLOSESTOPPLAYPAUSE
STANDBY-ON
Standby�On button. If the device respondsPREVNEXT
you do not need to program the remote. If
not, follow the steps below to program the
DVD
remote.
Look up the number for the device on
the list below:
1
1 Cable (CBL)
2 VCR
3 DVD
VCR
4 Satellite (SAT)
5 Amplifier (AMP).
Look up the number for the manufac-
turer on pages 24�25.
CBL
Press the Select and Standby�On but-
tons at the same time, then release.
2
2
Press the number for the device fol-
lowed by the manufacturers code. The
3
green Standby-On light will blink,
indicating the code is valid. If the light
does not blink, start again at step 1
using another code (if available).
2
3
22 |
ACEC
