Remote Control Y Working Accessory Devices
SETTINGTHE TV REMOTETO WORK ACCESSORY DEVICES
DIRECT ACCESS METHOD
ow that you have looked up thePOWER
Nthree-digit Remote Control Direct
Entry Code for your brand of acces-1
sory device, you are ready to followSatellite
Receiver
the simple steps shown below.
TVVCRACC
SWAPPIP CHSOURCE FREEZE
Please read through all the stepsCable TV
DNUP
Converter
before beginning.PICTURE
SOUND
BEGIN
DVD
STATUS/MENU/SELECT
First, press and hold down theEXIT
VCR or ACC (for an accessory
device other than a VCR) mode
VCRMUTE
button on the TV remote. Then pressCH
VOL
and hold down the MENU/SELECT
button at the same time for a brief1
moment. Release the buttons. The TV132
3
remote back light will switch on.
465
Within 30 seconds of pressingPOWER
798
the VCR (or ACC) button andTV/VCR
OKTV VCRA/CHSURF
MENU/SELECT button, enter aSWAPPIP CHSOURCEACC0
DNDNDNUPUPUPFREEZE
SOUND
three-digit code for the accessoryPICTURE
STATUS/EXITPOSITIONPIP2
device(see pages 47 and 48). MENU/SELECT
MUTE
VOL
Point the remote at the accessoryCH
1132
device.Then press the POWER but-23
464556
ton on the remote to turn the device79788
TV/VCR9
A/CH0A/CH0
on.CCSURF
POSITION
PIP
SMART HELP
NOTES:
Y Pressing the ACC(esso-
ry) mode button allows accessY If you do not enter a complete code
to the product codes for accessorywithin 30 seconds, you will need to
devices.perform step 1 of the Direct Access
Method again.
Y If the procedure explained above
does not work the first time,Y If you enter more than three digits,
repeat the steps using the samethe unit will retain the first three
remote code number.digits entered.
Y If after a second try the remote
does not operate your accessory
device, and more code numbers
are listed for your brand, use the
next listed code number.
Y If after repeated attempts the
Direct Access Method does not
allow you to work your accessory
device with your TV remote, try
the Search Method explained on
the next page.
45 |