1616ENGLISHENGLISH17
C6Open Razor Head assembly again andC4Remove and clean one set of cutters and
leave open to air dry.combs at a time.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue.This could damage the
shaving heads.
C5Separate the cutter from the comb and
C7If the shaving unit becomes detached fromrinse clean under hot water.
the razor, you can easily reattach it.
Do not clean more than one cutter and comb at a
8You may also clean the hair chambertime, since they are all matching sets. If you
without water by using the supplied brush.accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
Once A Month: Razor Headsperformance is restored.
Do not mix up the cutters and combs as theC6Replace the set back into the Razor Head
shaving performance may be adversely affected forAssembly so that the Owings� on the comb
several weeks before optimal shaving performancefit within the brackets located towards the
is restored.center of the Assembly.
1Turn razor OFF, remove the charging plugThe set will only fit into the Razor Head Assembly
from the outlet and cord from the razor.if the �wingsO are between the brackets. Make sure
that the two pointy edges of the head fit exactly
C2Press the razor head release button tointo the recesses.
open the razor head assembly.
7Repeat the process for the other two sets
of cutters and combs.
C3Turn the wheel counterclockwise (1) and
remove the retaining frame (2).8Replace the frame.
C9Press down (1) and turn wheel clockwise
(2) until it locks into place.
10Close the Razor Head Assembly. |
ACEC
