18ENGLISHENGLISH19
Preparing Jet Clean System For Use1 PlacetheJet Clean Systemonaflat,level
surface.
Important
� Only use the razor,power plug,Jet Clean SystemC2 Lift the transparent cleaning reservoir
and HQ200 cleaning solution provided to chargefrom the Jet Clean System.
or clean razor.
� Only use a Philips Norelco �XLCCO model C3 Turnthereservoircapcounterclockwise
razor with the Jet Clean System.(1) and remove from the cleaning
� Other Philips Norelco�XO,�XLO or�LCO modelreservoir (2).
razors DO NOT work with a Jet Clean System.
� Empty the cleaning solution canister and 4Unscrew the lid on the Jet Clean Solution
thoroughly rinse the canister clean with warm bottle (Model HQ200) provided with the
water every 2 weeks.razor. Remove the airtight seal by lifting up
� The Jet Clean System thoroughly cleans but the tabs on the seal. Replace lid on the bottle
does not disinfect your razor, therefore, do notmaking sure the lid is screwed on securely.
share razor with others.
� Thecharging plug converts 100-240VAC to5OpenlidandpourtheJetCleanSolutioninto
less than 24V DC.the transparent cleaning reservoir. The
� Place the Jet Clean System on a flat, stablereservoir can be completely filled with one
surface to avoid any leakage. Be careful not to tip(1) bottle of the Jet Clean Solution (Model
or move the Jet Clean System if it is filled with HQ200).Discard cleaning solution bottle
the cleaning solution.after contents have been poured into the
� To avoid evaporation, do not expose cleaning reservoir.
solution to direct sunlight.
� Remove the protective razor head cap from NOTE: ONLY USE PHILIPS NORELCO JET
the razor before charging or cleaning the razorCLEAN SOLUTION (MODEL HQ200)WITH
in the Jet Clean System.THE JET CLEAN SYSTEM. ANY OTHER
� Use this appliance for its intended household SOLUTION MAY CAUSE DAMAGE TO YOUR
use as described in this manual.RAZOR. |
ACEC
