20ENGLISHENGLISH21
C1The light above faucet symbol will start� Use this appliance for its intended household
blinking after each shave to remind youuse as described in this manual.
that the razor needs to be cleaned (except
when the bottom light burns red).1 PlacetheJet Clean Systemonaflat,level
surface.
Preparing Jet Clean System For Use
C2 Simultaneously press the buttons located
Importanton both sides of the Jet Clean System (1)
� Only use the razor,power plug,Jet Clean Systemand lift the appliance off the Jet Clean
and HQ200 cleaning solution provided tocanister (2).
charge or clean razor.Always remove appliance from canister by lifting
� Only use a Philips Norelco �XLCCO model straight up. Do not tilt Jet Clean System.
razor with the Jet Clean System.
� Other Philips Norelco�XO,�XLO or�LCO model3UnscrewthelidontheJetCleanSolution
razors DO NOT work with a Jet Clean System.bottle (Model HQ200) provided with the
� Empty the cleaning solution canister and razor. Remove the airtight seal by lifting up
thoroughly rinse the canister clean with warm the tabs on the seal. Replace lid on the bottle
water every 2 weeks.making sure the lid is screwed on securely.
� The Jet Clean System thoroughly cleans but
does not disinfect your razor, therefore, do notC4OpenlidandpourtheJetCleanSolutioninto
share razor with others.the canister up to the MAX indication
� Thecharging plug converts 100-240VAC tolocated inside the canister.
less than 24V DC.
� Place the Jet Clean System on a flat, stableNOTE: ONLY USE PHILIPS NORELCO JET
surface to avoid any leakage. Be careful not to tipCLEAN SOLUTION (MODEL HQ200)WITH
or move the Jet Clean System if it is filled with THE JET CLEAN SYSTEM. ANY OTHER
the cleaning solution.SOLUTION MAY CAUSE DAMAGE TO YOUR
� To avoid evaporation, do not expose cleaning RAZOR.
solution to direct sunlight.
� Remove the protective razor head cap from
the razor before charging or cleaning the razor
in the Jet Clean System. |
ACEC
