CAJ3080/00 page 4
CONTROLSINSTALLATIONRADIO/CLOCK
English
TOP AND SIDE PANELSsee fig.1MAINS CONNECTION
1 ALARM RESET - to stop the active alarm for 241.Check if the mains voltage as shown on the type
hours.plate on the base of the set corresponds to your
local mains supply.
2 SLUMBER - to activate slumber time.
2.Connect the mains plug into the wall socket. The
3 CLOCK:
mains supply is now switched on and the
� RUN - To return to clock time display after
numbers on the display will start to flash. You
setting clock/alarm time.
will need to set the correct time.
� ALARM - To adjust/review the alarm time.
3.To disconnect the set from the mains completely,
� TIME SET - To adjust clock time.
withdraw the mains plug from the wall socket.
� HR - To adjust the hours for the clock and alarm
For users in the U.K.: please follow the
time.
instructions on page 2.
� MIN - To adjust the minutes for the clock and
alarm time.FM/MW (LW) RADIO
4SLUMBEROFF / REPEAT ALARM
You can use the clock radio solely as a radio.
- to switch off slumber.
1.Set the RADIOswitch to ON.
- to stop the active alarm for a 9 minute period.
2.Select your wave range using the BAND switch.
5 Display - To show the hours, minutes and3.Use TUNING to find your radio station.
activated alarm4.Adjust the sound with the VOLUME control.
5.To turn off the radio, set the RADIO switch to OFF.
6 BAND - to select FM-MW(LW) wave range.
7 VOLUME - for adjusting the volume.To improve radio reception
� For MW (LW), the set is provided with a built-in
8 TUNING - to tune to radio stations.
aerial which to function best should be placed on
9 RADIO - to switch radio mode ON/OFF.a non-metallic surface e.g. wood, plastic. Direct
0 ALARM:the MW (LW) aerial by adjusting the position of
� OFF - to switch off alarm.your clock radio.
� RAD (io) - to activate radio for alarm setting.� For FM reception extend the pigtail aerial at
� BUZ (zer) - to activate buzzer for alarm setting.the back of the set completely to obtain
optimum reception.
BACK PANELsee fig.1
CLOCK
! Battery door - for mains backup battery.
Clock display
@ Mains lead - for mains supply.The time is displayed using the 24-hour clock
system.
# Pigtail aerial - for FM reception
Important!
When setting the clock alarm time, for accurate
hour and minute adjustment always make sure
you press the HR and MIN buttons separately
and not simultaneously.
4 |
ACEC
