AJ 3140/00. page 7
MaintenanceClock / Radio
MAINTENANCESETTING THE CLOCK
� If you do not intend to use the clock radio for a longClock display
English
time, disconnect the set by removing the plug fromThe time is shown and the display also indicates
the wall socket. The battery should also be removedwhether you have switched on the alarm(s), and these
to prevent danger of leakage which will damageindicators will light up respectively next to ALARM 1
your set.and ALARM 2 on the display:
� To clean your set from fingerprints, dust and dirt,
use a clean and soft damp cloth or chamois leather.1. Press and hold down the TIME button.
Do not use cleaning products which contain,2. Use the 4 and 7 buttons to set and adjust the hours
benzene, thinner, etc. as these may harm theand minutes.
housing.� With 7 pressed, the time will increase rapidly
� Avoid exposing the clock radio to rain, dampnessfrom minutes to hours. Release 7 when you have
and extreme heat to prevent a safety hazard as wellreached the correct setting.
as damage to the set.� Pressing 4 will allow you to adjust the time
slowly back minute by minute if necessary.
Environmental informationRADIO
All unnecessary packaging material has been
omitted. We have done our utmost to make theYou can use this clock solely as a radio.
packaging easily separable into three mono-1. Set the RADIO switch to ON.
materials: cardboard (box), expandable2. Select your wave band using the BAND switch.
polysyrene (buffer), polyethylene (bags,3. Tune to desired radio station using the
protective).TUNING knob.
4. Set the volume by turning the VOLUME knob.
Your set consists of materials which can be5. To turn off the radio, set the RADIO switch to OFF.
Antenna:recycled if disassembled by a specialized
� For FM reception, use the built-in pigtail aerial.company. Please observe the local regulations
Adjust the pigtail aerial slightly to obtain optimumregarding the disposal of packing materials,
reception if needed.exhausted batteries and old equipment.
� For MW/LW reception, the set is provided with a
built-in aerial. Simply by adjusting the position of
IMPORTANT NOTE FOR USERS IN THE U.K.: your clock radio, optimum reception can be
SEE PAGE 2obtained. Place the set on a non-metallic surface to
avoid any deterioration of MW/LW reception.
7 |
ACEC
