XP AJ 3290/00.1 22-06-2000 12:12 Pagina 5
AJ3290/00 page 5
CLOCKRADIOALARM
SETTING THE CLOCKSETTING THE ALARM
General
Clock displayEnglish
The time is displayed using the 24-hour clockIf you wish to use the alarm, then you should
first set the alarm time. There is also the choice
system.of two modes for waking you up: by buzzer or
1. Adjust the clock control to the TIME SET
position.radio. The display will show the alarm indicator
in the bottom left or right corners if the alarm is
2. Press and hold down the 7 or 4 buttons to
set and adjust both the hours and the minutes.set.
� With your finger held down on 7, the time1. Adjust the clock control to the ALARM 1 or 2
will increase rapidly and continuously fromposition.
minutes to hours.2. Press and hold down the 7 or 4 buttons to
� With your finger held down on 4, the timeset and adjust both the hours and the minutes.
will slowly count down minute by minute.� With your finger held down on 7, the time
3. Release the 8 or 4 buttons when you havewill increase rapidly and continuously from
reached the correct setting.minutes to hours.
4. To safeguard the clock time from being� With your finger held down on 4, the time
accidentally adjusted, turn the clock control towill slowly count down minute by minute.
the RUN position.3. Release the 7 or 4 buttons when you have
reached the correct setting.
4. Adjust the clock control to the RUN position toRADIO
return to clock time display.
You can use this clock solely as a radio.� To review your set alarm time, adjust the
1. Set the RAD switch to ON.clock control to the respective ALARM 1 or
2. Select your wave band using the BAND2 position.
switch.5. To select the alarm mode you wish to be
3. Tune to desired radio station using theawoken by, set the respective AL 1 or 2
TUNING knob.switch to RAD or BUZ.
4. Set the volume by turning the VOLUME control.� If you have selected the radio mode, make
5. To turn off the radio, set the RAD switch tosure you have adjusted the volume loud
OFF.enough to wake you.
To improve radio reception� The 2 buzzers are at a set volume and
� For AM, (MW or LW ) the set is provided withcannot be adjusted. BUZ on AL 1 is a low
a built-in aerial which to function best shouldtone buzzer while BUZ on AL 2 is a high
be placed on a non-metallic surface e.g.tone.
wood, plastic. Direct the MW aerial by
adjusting the position of your clock radio.
� For FM , extend the pigtail wire at the back of
the set completely for optimum reception.
5 |
ACEC
