XP AJ 3380/00.3 22-06-2000 12:14 Pagina 7
TROUBLESHOOTING
� If a fault occurs, first check the points listed below before taking the set for repair.
� If you are unable to remedy a problem by following the hints below, consult your dealer or service
centre.
English
WARNING: under no circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
PROBLEMTHE ALARM DOES NOT FUNCTION
� Possible cause� The alarm is not set
Y REMEDYY Set the alarm time and the alarm switch to
BUZor RAD.
NO SOUND
� Volume too low for radio.
� Volume not adjusted.Y Increase the volume.
Y Adjust the volume.
THE SLUMBER DOES NOT FUNCTION
MW (OR LW) BROADCAST CANNOT BE RECEIVED
PROPERLY� RADIO still in ON position.
Y Switch RADIO to OFF position.
� Weak radio signal.
Y Rotate the set for better reception and makeENVIRONMENTAL INFORMATION
sure the set is placed on a non-metallic
All unnecessary packaging material has been
surface.
omitted. We have tried to make the packaging
CONTINUOUS CRACKLING AND HISS NOISEeasy to separate into three mono-materials:
DURING MW (OR LW) RECEPTIONcardboard (box), expandable polystyrene (buffer),
� Interference from other electrical equipmentpolyethylene (bags).
e.g. TVOs, computers, fluorescent lamps.Your set consists of materials which can be
Y Move the clock radio away from electrical
recycled if disassembled by a specialized
equipment.company. Please observe the local regulations
INTERMITTENT CRACKLING SOUND DURING FMregarding the disposal of packing materials,
RECEPTIONexhausted batteries and old equipment.
� Weak signal.
Y Adjust the pigtail aerial.
The type-plate is located on the bottom of the clock radio.
This set complies with the radio interference requirements of the European Community.
7 |
ACEC
