XP AJ 3430/00 29-03-2000 16:21 Pagina 5
INSTALLATIONBASIC FEATURES
MAINS SUPPLY AND DEMO MODEILLUMINATION BRIGHTNESS
1. Check if the power voltage, shown on the type plate on the1. Check if the SET control is turned to CLOCK position and the
bottom of the set, corresponds to your local mains supply. Ifradio is switched off.English
it does not, consult your dealer or service centre.2. Press REPEAT ALARM/ BRIGHTNESSCONTROL once or more.
2. Connect the mains plug into the wall socket. The mains� The brightness of the display will change in this
supply is now switched on and the display will show thesequence:
PHILIPS demo mode.BRIGHT y MEDIUM y LOW y BRIGHT...
" PH..IL ..IPS scrolls across the display continuously.
Y Turn the SET control to SET TIME to exit the demo mode.Note:
3. To disconnect the set completely from the mains supply,when an alarm or the SLEEP function is active, brightness
withdraw the mains plug from the wall socket.cannot be adjusted.
POWER BACK-UPRESET
The power back-up conveniently allows your preset stations,Should the display and electronic functions of your set receive
alarm and clock time settings to be stored for up to 3 minutesinterference e.g. static electricity from carpets, thunderstorms,
when there is a power interruption e.g. AC mains failure.etc. RESET allows you to clear all previous settings and start
The complete clock radio and display illumination will beup again.
switched off. As soon as the mains supply returns, the displayY Use a ballpoint pen to press the RESET hole found on the
will indicate the correct time.bottom of the set.
If mains supply returns after 3 minutes and the display shows:
Y clock time blinking � indicates you need to re-adjust the
clock time
Y PHILIPS demo mode � indicates you need to re-enter preset
stations and the clock and alarm times.
5 |
ACEC
