AQ4130_61 IFU 29/11/05 15:53 Page 5
Power SupplyGeneral Operation / Radio
Using AC powerGeneral operation
1 Check if the power voltage, as shown onSwitching on and off and selecting
the type plate located on the functions
bottom of the set, corresponds to your
local power supply. If it does not, consult your1 To switch on, push the Source selector
dealer or service center.slider to TAPE or RADIO as desired.
2 If your set is equipped with a voltage 2 To switch off, push the Source selector
selector, adjust the selector so that it to TAPE (OFF) and check the cassette
matches with the local mains.keys are released.
3 Connect the power cord to the AC IN ~Helpful hints:
inlet and the wall socket.The power cord is
now connected and ready for use.To change fromTAPE to RADIO ,or when
you are switching off the set:first,make sure you
4 To switch the set off completely, withdraw thepress the STOPYEJECT 9/ key to end
power cord from the wall socket.playback and all the cassette keys are released.
Y Disconnect the power cord from the wall
socket to protect your set during heavy
thunderstorms.Adjusting volume
Y Adjust the volume with the VOLUME
control.
Helpful hints :To avoid unnecessary energy
consumption, always adjust the Source
Radio reception
selector to TAPE (OFF) after using the
set.Also check that the tape deck keys are1 Adjust the source selector to RADIO.
released.
2 Adjust the band selector to select your
desired waveband, MW,SWor FM.
The type plate is located on the bottom
of the set.3 Turn TUNING to tune to a station.
YIn SW, turnTONE for precise tuning.
4 To switch off the radio, adjust the source
selector to TAPE (OFF) position.
To improve radio reception:
Y For FM and SW, extend and turn the
telescopic antenna for best reception. Reduce
its length if the signal is too strong.
Y For MW, the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
5 |
ACEC
