XP AQ 6345/00 02-02-2000 11:02 Pagina 6
CASSETTE PLAYBACKRECORDING
EnglishCASSETTE PLAYBACK8. For brief interruptions, adjust PAUSE ;. To deactivate
1. Open the cassette door and insert a tape (see fig. 2). pause, slide the switch back again.
2. Press the door lightly to shut.9. To stop playback, press 9 and the set is switched off.
3. To start playback, press 1.Y At the end of a tape, the 1 key is automatically released
4. Adjust the sound with VOLUME.and the set switched off, unless PAUSE ; has been
Y For personal mono sound listening, insert 3.5mmactivated.
headphones (preferably type e16 ohms) into the p socket.
The built-in speaker will then be disconnected.
5. To fast wind, press 5 or 6.
GENERAL INFORMATION ON RECORDING
6. Watch the tape counter display to find the point in the tape
Y This set is not suited for recording on CHROME (IEC II) or
you want to listen to. Press 9 to stop fast winding at the
METAL (IEC IV) type cassettes. You should only use
selected point.
NORMAL type cassettes (IEC type I) on which the tabs have
Y 5 or 6 also allows you to fast cue or review during
not been broken.
playback. Using the tape counter to monitor passages, hold
Y Altering the VOLUME and TAPE SPEED controls will not
down on 5 or 6 and release the key at the passage you
affect the recording in progress with the exception of when
want. Tape playback continues from this point.
VOICE ACT is in use and VOLUME is adjusted.
Y To reset the tape counter display to 000, press the
Y At the very beginning and end of the tape, no recording will
COUNTER RESET switch.
take place during the 7 seconds when the leader tape
7. You can also adjust TAPE SPEED to find or listen to
passes the recorder heads.
passages during playback. Set TAPE SPEED to:
Y Recording is permissible insofar as copyright or other rights
Y for high speed playback;
of third parties are not infringed.
Y 0 for normal speed playback;
Yfor low speed playback.
-
Remember to set TAPE SPEED to 0 for normal playback!
6 |
ACEC
