AQ 6688 /00 - page 4
POWER SUPPLY
EnglishMains adapterMEMORY PROTECTION
The voltage of the 3V adapter must match with the localThe memory protection acts as a backup should there be a
voltage. The 3.5 mm adapter plugOs 1.3 mm centre pin mustpower failure or interruption.
also be connected to the minus pole -.When changing batteries or power supply, the time setting,
Y Connect the mains adapter to the setOs DC 3V socket.presets and the last station listened to are retained for
Y Always disconnect the mains adapter if you are not using it.approximately 2 minutes. This allows you to change batteries
or power supply without having to set your stored data all over
Battery (optional)again.
Y Open battery door and insert two alkaline batteries, type R6,
UM3 or AA as indicated.Use of Philips POWERLIFE
batteries gives up to 18 hours of cassette playback.
Y Remove the batteries from the set if they are exhausted or
not to be used for a long time.
a When the batteries are running low, will flash
briefly in the display and you should insert new batteries.
If the radio is on, it will automatically switch off.
a It may be necessary to reprogramme your preset stations.
4 |
ACEC
