AZ1006-Eng 3/25/05 14:28 Page 9
Cassette RecorderMaintenance
Recording from the RadioTape deck maintenance (See 7)
1 Adjust the Source selector to MW or
To ensure quality recording and playback of
FM to select your desired waveband.the tape deck, clean parts A, B and C as
2 Tune to the desired radio station (see Radioshown, once a month. Use a cotton bud
reception).slightly moistened with alcohol or a special
3 Follow steps 3-6 under CD sychro starthead cleaning fluid to clean the deck.
1 Open the cassette holder by pressing 9/.
recording.
2 Press 1 and clean the roller C.
Precautions & General3 Press ; and clean the heads A, and the
Maintenance (See 7)capstan B.
Y Place the set on a hard, flat and stable surface4 After cleaning, press 9.
� Cleaning of the heads can also be done by
so that the system does not tilt.
playing a cleaning cassette through once.
Y Do not expose the set, batteries, CDs to
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.CD player and CD handling (See 7)
Y The apparatus shall not be exposed to drip-Y If the CD player cannot read CDs correctly,
ping or splashing.use a cleaning CD to clean the lens before
taking the set to repair.
Y Adequate ventilation with a minimum gap of
15 cm between the ventilation holes and sur-Y The lens of the CD player should never be
rounding surfaces is necessary to preventtouched!
heat build-up.Y Sudden changes in the surrounding
Y The ventilation should not be impeded bytemperature can cause condensation on the
lens of your CD player. Playing a CD is then
covering the ventilation openings with items,
such as newspapers, table-cloths, curtains, etc..not possible. Do not attempt to clean the
lens but leave the set in a warm environment
Y No objects filled with liquids, such as vases,until the moisture evaporates.
shall be placed on the apparatus.
YAlways close the CD-tape door to avoid dust
Y No naked flame sources, such as lighted can-on the lens.
dles, should be placed on the apparatus.
YTo clean the CD, wipe in a straight line from
Y The mechanical parts of the set contain the center towards the edge using a soft,
self-lubricating bearings and must not be oiledlint-free cloth. Do not use cleaning agents as
or lubricated.they may damage the disc.
YTo clean the set, use a dry cloth. Do not useY Never write on a CD or attach any stickers
any cleaning agents containing alcohol,to it.
ammonia, benzene or abrasives as these may
harm the housing. |
ACEC
