XP AZ 1008/17 13-10-2000 17:28 Pagina 9
Power Supply
Incorrect use of batteries can cause
Switching power on/off:
electrolyte leakage and will corrode the
Save energy
compartment or cause the batteries to
English
burst.Therefore:Whether you are using mains or battery
supply, to avoid unnecessary energy
Y Do not mix battery types: e.g. alkaline with
consumption always adjust the source
carbon zinc. Only use batteries of the same
selector to TAPE/OFF and check if the
type for the set.
cassette keys are released.
Y When inserting new batteries, do not try to
Standby power consumption...................3 W
mix old batteries with the new ones.
Y Remove the batteries if the set is not to be
8RECORDER
CDRAADIOZC1ASS0ET0TENG
used for a long time.CDSYNCHROSTARTRECORDILFITTONPOE
TUNING
LIFTTOOPECMNDARCHSEARCHPLAY
TWAFMPSTOPYOPENSEVOLUM
Using AC PowerTT.LOWOFFPAUSEE
BA
CD TRACKREPEATEPROGRAM
1 Check if the power voltage, as shown onUS/PASTYOAP
LPEATPROGRAM
P
the type plate located on the bottomSEARCHICBASSBOOSRE
DYNAMT
of the set, corresponds to your localDBB
power supply. If it does not, consult your
dealer or service center.
ACMAINS~
General operation
1 To select your sound source adjust the
source selector to CD, AM, FM or
TAPE/OFF.
2 Adjust the sound with the VOLUME and
DBB (Dynamic Bass Boost) controls.
3 To switch off the set, adjust the source
selector to TAPE/OFF position and check
2 Connect the power cord to the AC MAINS
the cassette keys are released.
inlet and the wall outlet.The power supply
is now connected and ready for use.
3 To switch off completely, unplug the power
cord from the wall outlet.
Y Unplug the power cord from the wall
outlet to protect your set during heavy
thunderstorms.
The type plate is located on the
bottom of the set.
9 |
ACEC
