BASIC FUNCTIONSRADIO
EnglishSwitching the set on and off
Set the POWER slider to the desired sound source: CD, TAPE, or
TAPEOFFBANDFM
BAND (for radio).CDAM
POWER
The set is switched off when the POWER slider is set to OOFFFF/TAPEDBBDYNAMIC
BASS BOOST
and the keys of the tape deck are released.
CD SYNCHRO STA
R
Note: If you use batteries, switch the set off after use. This will
avoid unnecessary power consumption.
Adjusting volume and sound
Adjust the volume using the VOLUME control.
POWER
DBBDYNAMIC
BASS
Increase and decrease the bass level by pressing DBB. BOOST
CD SYNCHRO STA
R
The bass level can also be emphasised if you place the set against
VOLUME
wall or shelf. Do not cover any vents; leave sufficient room around
the unit for ventilation.
Radio � tuning to radio stations
1 Set the POWER slider to FM or MW to select the desired
wave band.FM AM
1081700
1041300
100
2 Tune to the desired radio station by using the TUNING wheel.1000
98800
HRO START RECORDING
97630
Improving RADIO reception
OPEN
For FM stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
For MW stations, direct the built-in antenna by turning the whole
set. The telescopic antenna is not needed.
8 |