AZ 1045/00 page 7
DIGITAL TUNER
TUNING TO RADIO STATIONS
T
1. Select TUNER source.UNER
"is displayed briefly and then the radio stationMODEEnglish
frequency is shown.PLAYYPAUSESTOPPROGBLAOTWT
2. Press BAND once or more to select your waveband.SEARCH
3. Press SEARCH or § (on the remote control,
TUNING or §) and release when the frequency in the
display starts running.
" The TUNER automatically tunes to a station of sufficient
reception. Display shows during automatic tuning.
" If a FM station is received in stereo, STEREO is shown.
4. Repeat step 3 if necessary until you find the desired station.
Y To tune to a weak station, press SEARCH or § briefly and
repeatedly until you have found optimal reception.
To improve radio reception
� For FM, pull out the telescopic aerial. Incline and turn the
aerial. Reduce its length if the signal is too strong (very close
to a transmitter).
� For MW/LW, the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning the
whole set.
5. Adjust the sound using VOLUME and DBB.
6. Adjust the POWER slider to the TAPE/OFF position to switch
off the set.
STEREO FM
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).ENMSOOTESHUFFLEALL
R
DIG
2. Press PROG to activate programming.RTUITNEAL
PRESETBAND
� Display: PROGRAM flashes.
3. Press PRESET 4 or 3 once or more to allocate a number fromLAYYPAUSESTOPPROGBLAOTWT
1 to 30 to this station.SEARCH
4. Press PROG again to confirm the setting.
� Display: PROGRAM disappears, the preset number and the
frequency of the preset station are shown.
5. Repeat the above four steps to store other stations.
� You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press PRESET 4 or 3 until the desired preset station is displayed.
AYRECORD
SHUFFLEALL
RTDIGUITNEAL
PRESETBAND
BLAOTWT
OPPROG
7 |
ACEC
