AZ1080/01 03/07/02 11:31 Page 7
Power Supply
Batteries contain chemical substances,4 To switch off completely, unplug the mains
so they should be disposed of properly.lead from the wall socket.
Incorrect use of batteries can causeY Unplug the mains lead from the wall socketEnglish
electrolyte leakage and will corrode theto protect your set during heavy
compartment or cause the batteries tothunderstorms.
burst.Therefore:
The type plate is located on the
Y Do not mix battery types: e.g. alkaline withbottom of the set.
carbon zinc. Only use batteries of the same
type for the set.Switching power on/off:
Save energy
Y When inserting new batteries, do not try to
mix old batteries with the new ones.Whether you are using mains or battery
supply, to avoid unnecessary energy
Y Remove the batteries if the set is not to be
consumption always adjust the source
used for a long time.
selector to TAPE/OFF and check if the
cassette keys are released.
Using AC Mains
8M0ACHINE
1 Check if the mains voltage, as shown onCADZSO1UN0DITABLECOMPATIBLE
CDREWRLIFTTONEPO
the type plate located on the bottomNITUNG
IFTTOOPELCNDEARCHSEARCHPLAY
MWS
of the set, corresponds to your localTFAOMPFFPAUSESTOPYOPENVOLUME
power supply. If it does not, consult yourCD TRACKREPEATE
USSTY
dealer or service centre./PAOAPLPATSHUFFLEE
A~SEARCHNAMICBASSBOOSTREP
DY
DBB
General operation
1 To select your sound source adjust the
source selector to CD, AM (MW), FM or
TAPE/OFF.
2 Adjust the sound with the VOLUME and
2 Connect the mains lead to the AC MAINS
DBB (Dynamic Bass Boost) controls.
inlet and the wall socket.The power supply
is now connected and ready for use.3 To switch off the set, adjust the source
selector to TAPE/OFF position and check
3 If your set is equipped with a voltage
the cassette keys are released.
selector, located inside the battery
compartment, adjust the selector to match
the local mains. Disconnect the mains lead if
this selector has to be reset.
7 |
ACEC
