XP AZ 1138/00-1 09-08-2001 18:20 Pagina 15
Troubleshooting
If a fault occurs,Å¢rst check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.If you are unable to remedy a
problem by following these hints,consult your dealer or service centre.
EnglishWARNING:Under no circumstances should you try to repair the set yourself,as
this will invalidate the guarantee.
ProblemSolution
No sound/ power � Volume not adjusted.Adjust the VOLUME.
� Mains cord not securely connected.
Connect AC mains cord properly.
� Batteries exhausted /incorrectly inserted.
Insert (fresh) batteries correctly.
Display does not function � Electrostatic discharge.
properly/ No reaction to Switch off and unplug the set.
operation of any of the controls Reconnect after a few seconds.
no d1SC, Cd Err or � No disc inserted. Insert a disc.
nF d1SC indication/ MP3CD/ � Disc badly scratched/ dirty.
CD playback does not workReplace/ clean disc (see maintenance).
� CD-R(W) is blank or the disc is not Ţnalised.
Use a Ţnalised CD-R(W).
� Laser lens steamed up.
Wait until lens has recovered to room temperature.
� Incompatible format used for MP3. Check if your disc
format is ISO 9960, Joliet, Ţnalised multisession.
The disc skips tracks� Disc damaged or dirty. Replace or clean CD.
� SHUFFLE or a programme is active.
Quit SHUFFLE/ programme mode.
Sound skips during � MP3Ţle made at compression level exceeding 320 kbps.
MP3 playbackUse a lower compression level to record CD tracks
into MP3 format.
Cannot Ţnd desired MP3 title � Wrong Ţle extension/ used.
Change Ţle extension to .MP3
Poor cassette sound quality� Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
� Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording.
Recording does not work� Cassette tab(s) may be broken.Apply a piece of
adhesive tape over the missing tab space.
15 |
ACEC
