AZ 1140/00 page 13
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under noEnglish
circumstances should you try to repair the set yourself, as this would
invalidate the guarantee.
PROBLEM
� POSSIBLE CAUSEindication
Y REMEDY� CD-R(W) is blank or the disc is not finalised
Y Use a finalised CD-R(W)
No sound/power
� VOLUME not adjusted� CD badly scratched or dirty
Y Adjust the VOLUMEY Replace/ clean CD, see CD player and
CD handling
� Headphones connected
Y Disconnect headphonesThe CD skips tracks
� Mains lead not securely connected� CD is damaged or dirty
Y Connect the mains lead properlyY Replace or clean the CD
Severe radio hum or noise� SHUFFLE or a programme is active
Y Switch off SHUFFLE/PROGRAM
� Electrical interference: set too close to TV,
VCR or computerPoor cassette sound quality
Y Increase the distance� Dust and dirt on the heads, etc.
Y Clean deck parts etc., see Maintenance
Poor radio reception
� Use of incompatible cassette types (METAL
� Weak radio signalor CHROME)
Y FM: Direct the FM telescopic aerial forY Only use NORMAL (IEC I) for recording
optimum reception
Y MW/LW: Turn the set for optimum receptionRecording does not work
� Cassette tab(s) may be broken
or indicationY Apply a piece of adhesive tape over the
missing tab space
� No CD inserted
Y Insert a CD
� CD badly scratched or dirty
Y Replace/ clean CD, see CD player and
CD handling
� Laser lens steamed up,
Y Wait until lens has cleared
This product complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set.
13 |
ACEC
