Power Supply
Remote control ? Disconnect the power cord from the wall
Important! socket to protect your set during heavy
Before using the remote control,removethunderstorms. Children could seriously injure
the insulation plastic tab as shown themselves as the free end of the cable may
in figure 9.still be live if only the connector is removed
If the remote control does not functionfrom the MAINS socket at the back of the
correctly or the operating range isunit.
reduced,replace the battery with a new
(CR2025) type battery.The type plate is located on the
1 Pull the battery tray out as shown bottom of the set.
in figure 9.
2 Replace a new battery according to polarityAuto power saving
? In CD and DOCK mode, if AZ1330D is in
indication, and fully insert the battery traythe PAUSE position for 5 minutes, it will auto
back to the original position.switch to the stop position.
? Incorrect use of batteries can cause
? In CD and DOCK mode, if AZ1330D is in
electrolyte leakage and will corrode the the STOP position for 15 minutes, it will auto
compartment or cause the batteries to burst:switch to standby to save power.
? Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the sameHelpful hints:
type for the set.? To avoid unnecessary energy consumption,
always press POWER on the set to power
? When inserting new batteries, do not try to
mix old batteries with the new ones.off the set after using the set.
Remove the batteries if the set is not to be
used for a long time.CAUTION
Batteries contain chemical substances,so- Visible and invisible laser radiation.
they should be disposed of properly.If the cover is open,do not look at
the beam.
Using AC power
- High voltage! Do not open.You run
1 Check if the power/mains voltage, as shownthe risk of getting an electric shock.
on the type plate located on the The machine does not contain any
bottom of the set, corresponds to youruser-serviceable parts.
local power supply. If it does not, consult your- Modification of the product could
dealer or service center.result in hazardous radiation of
2 Connect the power cord to theEMC or other unsafe operation.
AC~ MAINS inlet and the wall socket.The
set is now ready for use.This set complies with the radio
interference requirements of the
3 To switch the set off completely, withdraw
the power cord from the wall socket.European Union.
4 Install the unit near the AC outlet and where
the AC power plug can be easily reached. |
ACEC
