XP AZ 2025/17.1 08-05-2000 16:10 Pagina 11
AZ 2025 /17 page 11
DIGITAL TUNER
GENERAL INFORMATION
General maintenance
Y Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
Englishdirect sunlight.
Y To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
Y Place the set on a hard and flat surface so that the system does
not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.
Y The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated.
TUNING TO RADIO STATIONS
1. Select TUNER source.
"is displayed briefly and then the radio station frequency isATWT
shown.
2. Press BAND once or more to select your waveband.
3. Press SEARCH or § (on the remote control,
TUNING or §) and release when the frequency in the
display starts running.
" The tuner automatically tunes to a station of sufficient
reception. Display shows during automatic tuning.
" If an FM station is received in stereo, STEREO is shown.
4. Repeat step 3 if necessary until you find the desired station.
Y To tune to a weak station, press SEARCH or § briefly and
repeatedly until you have found optimal reception.
To improve radio reception
� For FM, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very close
to a transmitter).
� For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by turning
the whole set.
11 |
ACEC
