XP AZ 203x/17.2 09-01-2001 15:25 Pagina 9
AZ 2030 /17 page 9
POWER SUPPLY
Whenever convenient, use the power supply if you want to
conserve battery life. Make sure you remove the power plug from
the set and wall outlet before inserting batteries.
BATTERIES (not included)
English
1. Open the battery compartment and insert 8 batteries,
type R-20, UM-1 or D-cells, (preferably alkaline) with the
correct polarity as indicated by the "+" and "�" symbols inside8 x R20 Y UM-1 Y D-CELLS
the compartment.
Remote control (for AZ2035 model only)
Open the battery compartment and insert two batteries,
type AAA, R03 or UM4 (preferably alkaline).
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
� If BATT LOW lights up, battery power is running low.
� The BATT LOW indicator eventually goes out if the
batteries are too weak.
Incorrect use of batteries can cause electrolyte leakage and will
corrode the compartment or cause the batteries to burst.
Therefore:
Y Do not mix battery types: e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
Y When inserting new batteries, do not try to mix old batteries
with the new ones.
Y Remove the batteries if the set is not to be used for a long
time.
Y Batteries contain chemical substances, so they should
be disposed of properly.
Using AC POWER
1. Check if the power supply, as shown on the type plate
located on the bottom of the set, corresponds to your local
power supply. If it does not, consult your dealer or service
center.
2. If your set is equipped with a voltage selector, adjust the
selector so that it matches with the local power.
3. Connect the power cord to the wall outlet and the set is now
ready for use.
4. To disconnect the set from the power supply completely,
remove the power plug from the wall outlet.
9 |
ACEC
