AZ 2785 /17 page 18
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
English
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
PROBLEMThe CD skips tracks
� POSSIBLE CAUSE� CD is damaged or dirty
Y REMEDYY Replace or clean the CD
� SHUFFLE or a program is active
No sound/power
� VOLUME is not adjustedY Quit SHUFFLE/PROGRAM mode(s)
Y Adjust the VOLUMEPoor cassette sound quality
� Headphones connected� Dust and dirt on the heads, etc.
Y Disconnect headphonesY Clean deck parts etc., see maintenance
� Power cord not securely connected� Use of incompatible cassette types (METAL
Y Connect AC power cord properlyor CHROME).
� Batteries dead/ incorrectly insertedY Only use NORMAL (IEC I) for recording.
Y Insert (fresh) batteries correctlyRecording does not work
Display does not function properly/ No� Cassette tab(s) may be broken
reaction to operation of any of the controlsY Apply a piece of adhesive tape over the
� Electrostatic dischargemissing tab space.
Y Switch off set, disconnect the power plug
and reconnect after a few seconds
CD playback does not work
� CD is badly scratched/ dirtyRemote control does not function properly
Y Replace/ clean CD (see MAINTENANCE)� Batteries dead/ incorrectly inserted
� Laser lens steamed upY Insert (fresh) batteries correctly
Y Wait until lens has acclimatized� Distance between the set too large
Y Reduce the distance
Environmental information
All unnecessary packaging material has been omitted. The packaging can be easily separated into
three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, dead batteries and old equipment.
18 |
ACEC
