XP AZ 4000/17 18-09-2001 15:04 Pagina 19
Troubleshooting
If a fault occurs,Å¢rst check the points listed below before taking the set for repair.Do
not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints,consult your dealer or
Englishservice center.
WARNING:Under no circumstances should you try to repair the set yourself,as this
will invalidate the warranty.
ProblemSolution
No sound/power� Volume not adjusted.Adjust the VOLUME.
� Power cord not securely connected.
Connect AC power cord properly.
� Batteries dead /incorrectly inserted.
Insert (fresh) batteries correctly.
Display does not function � Electrostatic discharge.
properly/ No reaction to Switch off and unplug the set.
operation of any of the Reconnect after a few seconds.
controls
INSERT CD or CHECK DISC � No CD inserted, insert a CD.
indication� CD badly scratched or dirty.
Replace/ clean CD (see Maintenance).
� Laser lens steamed up.Wait until lens has cleared.
� CD-R(W) is blank or the disc is not Ţnalized.
Use a Ţnalized CD-R(W).
CD playback does not work� CD badly scratched/ dirty.
Replace/ clean CD (see Maintenance).
� Laser lens steamed up.
Wait until lens has acclimatized.
The CD skips tracks� Disc damaged or dirty. Replace or clean disc.
� SHUFFLE or a program is active.
Quit SHUFFLE / program mode(s).
19 |
ACEC
