32 Timer Recording
Follow the steps below to program the TV/VCR to record TV
programs while youOre away from home. The TV/VCR will turn
2-3
itself on, record, and turn itself off automatically. Before you begin,
make sure:
lThe clock is set. If not, CLOCK MUST BE SET appears, fol-
lowed by the SET CLOCK menu.POWERSLEEP
lChannels are set up.
lThere is a tape in the TV/VCR. (Make sure the tapeOs record
tab is intact and the tape is long enough to record the pro-
PLAY
gram.)REWF.FWD
Complete each step within 60 seconds of completing theSTOP
previous step. If you donOt, you may start again at step 1.MENUSTATUS/EXITCLEAR
1
123
1CH.456
Press the MENU button.
789
0ALT. CHVOL.
SPEEDMEMORYPAUSE/STILL
>PRIM. SETUPPRESS B
VCR PROGRAMREC/OTRTRACKINGMUTE
VCR SETUP
CAPTION
REMINDER
BRIGHTNESS
2
Press the PLAY/s button or the STOP/t button to select
VCR PROGRAM, then press the F.FWD/B button.
VCR PROGRAM
>ONCE
DAILY(MON-FRI)
WEEKLY
PROGRAM REVIEW
SELECT KL CHOOSE B
TO END PRESS EXIT
3
Press the PLAY/s button or the STOP/t button to select
a ONCE, DAILY, OR WEEKLY recording. Then, press
Helpful Hints
the F.FWD/B button.
lONCE: The TV/VCR will record a TVprogram on any day youY If the power fails, programmed
choose, up to 12 months away.timer recordings will be restored
lDAILY:The TV/VCR will record every day from Monday towhen the clock is reset. (The clock
Friday � starting at the same time and recording the same channelwill reset itself automatically if you
for the same length of time.are using the AUTO CLOCK feature.
lWEEKLY: The TV/VCR will record the same channel on theDetails are on pages 14-17. If you
same day, at the same time, and for the same length of timeare not using the AUTO CLOCK
every week.feature, reset the clock manually.
Details are on pages 12-13.) The
DAILY PROGRAM (MON-FRI)
DailyPROGRAM -1 2 3 4 5 6 7 8-timer recording will not occur only if
Recordingthe timer recording was scheduled
(example)to take place during the power fail-
SELECT PROGRAM NUMBER
ure.
TO END PRESS EXIT
Y You cannot set a timer recording if
DEFEATRECORDING is set to ON.
Details are on page 36. |
ACEC
