44 SmartLock (contOd)
To change the access code, follow these steps.
1
2,4
Press the MENU button.
>SMARTLOCKPRESS BPOWERSLEEP
REVIEW
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
PLAY
REWF.FWD
STOP
MENU
2STATUS/EXITCLEAR
Press the PLAY/s button or the STOP/t button to select1
1236
SMARTLOCK. Then, press the F.FWD/B button.
CH.
456
SMARTLOCK
789
_ _ _ _
53
0ALT. CHVOL.
SPEEDMEMORYPAUSE/STILL
Enter Your Access Code
REC/OTRTRACKINGMUTE
3
Use the Number buttons to enter your old access code.
The default code is 0711. If you have never set up your personal
access code, use 0711 now.
After you enter the code, the SMARTLOCK menu will appear.
SMARTLOCK
X X X -
Enter Your Access Code
Helpful Hints
4
Y In order to protect the privacy of
Press the PLAY/s button or the STOP/t button to select
the access code, an X will appear
CHANGE CODE. Then, press the F.FWD/B button.
on the screen instead of the num-
SMARTLOCK
ber you enter.
BLOCK
Y If a OWrong Code...� message
>CHANGE CODE
appears on the screen after you
SELECT KL CHOOSE Bcomplete step 5, you entered the
TO END PRESS EXIT
wrong numbers in the Confirm Code
space. Repeat the steps on this
page.
5
Y You cannot use the default code
Use the Number buttons to enter your desired access codeafter you set up your personal
in the New Code space. Then, enter the same code in theaccess code.
Confirm Code space.Y If a power failure occurs, the
Your new access code should be recorded. You will return to thedefault code, 0711, will be the
SMARTLOCK menu.active access code again.
Y If you connect the power cord to an
New Code_ _ _ _
AC outlet that is controlled by a wall
Confirm Code_ _ _ _
switch, your personal access code
will be erased every time you turn
off the power at the wall switch.
The default code will be the active
6
code again.
Press the STATUS/EXIT button. |
ACEC
