CCZ196comb.QX33 4/6/99 7:05 PM Page 36
36 Timer Recording (contOd)
4
Use the Number buttons (1 - 8) to select a position in
which to store the timer recording. Flashing numbers indi-
4-7
cate an open position (one in which a timer recording has not yet
been stored).
NOTE: If you select a number that has already been used to store a
POWEREJECT
timer recording, PREVIOUSLYSETPROGRAM will appear on-screen for
a few seconds. Then information about the program in that positionSLEEPSPEEDMEMORY
will appear on-screen. If this happens, press the STATUS/EXIT button.REC/OTRPAUSE/STILL
Then use the Number buttons to select another position.
PLAY
REWF.FWD
STOP
5
MENUCLEAR
lEnter the channel of the TVprogram you want to record (youSTATUS/EXIT
must enter a 0 before all single-digit channels).
lIf you are recording from line input, press 0, 0. A/V INwill
123
appear on-screen.CH.
456
lIf you are recording using a Cable Box, enter the Cable Box
output channel (03 or 04). Be sure to select the channel of the789
TV program at the Cable Box and leave the Cable Box on forA.CH0+100
VOL.
the timer recording.CABLE/DBSCOMBI
ONE TIME PROGRAMVAR.SLOW/ENTERMUTEVCR PLUS+
PROGRAM 1TRACKINGF.ADVSLOW
CHANNEL � �SMARTPICTURE SMARTSKIPSOUNDSEARCHINDEXSEARCH
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
6
Press two Number buttons for the hour(s) you want the
recording to begin. Press two Number buttons for the
minute(s) you want the recording to begin. Press 1 for
AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON � � : � �
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
Helpful Hints
7
Y If the numbers entered do not
Follow the instructions in step 6 to set the recordingOs
match the TV/VCROs calendar, the
stop time. (AM or PM will be set automatically.)
entry will be rejected and a question
ONE TIME PROGRAM
mark will appear on-screen.
PROGRAM 1
Y To make corrections while you are
CHANNEL 10
TIME ON 09:30 PMprogramming a timer recording,
TIME OFF � � : � �
press the CLEAR button until the
cursor is flashing on the item you
TO CORRECT PRESS CLEAR
TO END PRESS EXITwant to change. Then enter the cor-
rect information.
Instructions continue on page 37. |
ACEC
