press ,, enter 4-digit PIN
default PIN is 00004Using your
press in idle mode to its
default settings.The handsetphone
will go back to country code
selection screen and you can
select the country code again. If4.1Make a call
country selection is not
needed, the handset will go
4.1.1 Predialling
back to idle screen after reset.
1Enter the phone number
(maximum 24 digits)
3.5Register your handset
You will need to register your2Press to dial the number
new handset or if you wish toY The call is initiated.
register the handset to a
different base unit.You can4.1.2 Direct dialling
1Press to take the line
register up to four handsets on
a single base station.2Enter the phone number
Before entering the 4-digit PIN,Y The call is initiated.
press on the base unit for
around three seconds when4.1.3 Call from the call
the base is in standby mode.log
1Press ,This feature is available if you
have subscribed the Caller Line
2Enter the default or
Identification service (CLI) with
existing 4-digit PIN code.your network provider.
Default PIN is 0000
1Press to show the
3Press to start registrationlatest call log entry
Note2Press repeatedly to
If the PIN code you entered isscroll through the list of
incorrect, a long beep isunanswered calls to select
emitted and the phone returnsyour desired unanswered
to standby mode.call
3Press to dial the
selected number
16Getting started |
ACEC
