xp CDR 600/00_01 English 06-04-2001 18:20 Pagina 27
Troubleshooting
WARNING
Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee.
Do not open the set as there is a risk of electric shock.
If a fault occurs,Å¢rst check the points listed,before taking the set for repair.If you are unable to solve a problem
by following these hints,consult your dealer or service centre.English
Laser safety
This unit employs a laser.Only a qualiŢed service person should remove
the cover or attempt to service this device,due to possible eye injury.
ProblemSolution:
No power� ensure that the ON/OFF key is in the on position (red LED on):
the CD recorder is in standby mode, press any key to activate it
� make sure that the power cable is plugged in correctly
� switch the recorder OFF and then immediately back ON
No sound� check the audio connections
� try using a different source on the ampliŢer
AmpliŢer sound is distorted� make sure that the CD recorder analog output is not connected to the
ampliŢer Phono input
Play will not start� make sure that the label of the CD is facing up
� clean the disc
� make sure that the disc is not defective by trying another disc
Remote control does not work� press CDR on the remote control and try again
� point the remote control directly at the CD recorder
� check the batteries and replace if necessary
� select the right source Ţrst
Will not record� clean the disc
� check if CDR(W) is an unŢnalized disc
� check that the disc is recordable and replace if necessary
� the disc is not an AUDIO disc (WRONG DISC)
� wrong input source chosen. Input label �ashing (CHECK INPUT)
� try using a Philips Audio CDR(W)
Recording is distorted� make sure the recording level is correct
20 second pause between recordings� see OAutostart recordingO.
Recorder does not react� switch the ON/OFF button on the front of the recorder off and back on
DISC RECOVER on display� a power failure has occurred during recording; the CD recorder is attempting
to repair the disc
DISC ERROR appears on the display� the disc cannot be recorded further, and cannot be Ţnalized.
� on a CDRW disc, the track being recorded is lost, but further recording and
Å¢nalization can still be done
Recorded tracks do not start or stop� try another auto track setting
at the correct time or tracks have � check if there are at least 2.7 seconds silence in between the tracks
been merged together(analog recording only)
� insert track increments manually with the remote control
START SOURCE indication� start the synchronized external recording by pressing PLAY on the external
source you wish to record from.
27 |
ACEC
