DECT623_627_GBIE_part1.qxd 14.07.2005 16:05 Seite 10
Conformity,environment and safety
Safety information
This equipment is not designed to make emergency calls when the power fails.An alternative has to be
made available to allow emergency calls.
Conformity
Hereby, Philips declares that the DECT 623xx and DECT 627xx are in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.This product can only be
connected to the analogue telephone networks of the countries mentioned on the packaging.
Power requirements
This product requires an electrical supply of 220-240 volts, alternating monophased power, excluding IT
installations defined in standard EN 60-950. In case of power failure, the communication can be lost.
Warning !
The electrical network is classified as hazardous according to criteria in the standard EN 60-950.The
only way to power down this product is to unplug the power supply unit from the electrical outlet.
Ensure the electrical outlet is located close to the apparatus and is always easily accessible.
Telephone connection
The voltage on the network is classified as TNV-3 (Telecommunication Network Voltages), as defined in
the standard EN 60-950.
Safety precautions
Do not allow the handset to come into contact with water. Do not open the handset or the base
station.You could be exposed to high voltages. Do not allow the charging contacts or the battery to
come into contact with conductive materials. Never use any battery type other than the one supplied :
risk of explosion.
Handsfree activation could suddenly increase the volume in the earpiece to a very high level. Make sure
the handset is not too close to your ear.
Environmental care
Please remember to observe the local regulations regarding the disposal of your packaging materials,
exhausted batteries and old phone and, where possible, promote their recycling.
Recycling & disposal
Disposal instructions for old products.
The purpose of the WEEE directive (Waste Electrical and Electronic Equipment; 2002/96/EC) is to
ensure that products are recycled using best available treatment, recovery and recycling techniques to
ensure human health and high environmental protection.
Your product is designed and manufactured with high quality materials and components,
which can be recycled and reused.
Do not dispose of your old product in your general household waste bin.
Inform yourself about the local separate collection system for electrical and electronic
products marked by this symbol :
Use one of the following disposal options :
1. Dispose of the complete product (including its cables, plugs and accessories) in the designated
WEEE collection facilities.
2. If you purchase a replacement product, hand your complete old product back to the retailer.
He should accept it as required by the WEEE directive.
10Conformity, environment and safety |
ACEC
