General explanation
AMPLIFIER
About this manual
English
This manual gives the basic instructions for operating the
TV
DVD player. Some DVDs require specific operation or
allow only limited operation during playback. When this
occurs, the symbol ? appears on the TV screen, indicating
that the operation is not permitted by the player or the
disc.
FAYX
Z
Remote control operation
? Unless stated, all operations can be performed by the
remote control. Always point the remote control directly at
PCM-MPEG2-Dolby Digital-DTSDIGITAL AUDIO OUT
the player, making sure there are no obstructions between
RL(CVBS)PR/CRPB/CBYS-VIDEO
COAXIALAUDIO OUTVIDEO OUTthe remote and the player.
Corresponding keys on the front panel of the player can
also be used.
Note:
Menu bar operation
� If the audio format of the digital output does not match the
capabilities of your receiver, the receiver will produce a strong,? A number of operations can be done with the menu bar
distorted sound or no sound at all.on the screen. The menu bar can be accessed by pressing
� Six Channel Digital Surround Sound via digital connectionthe cursor keys on the remote control.
can only be obtained if your receiver has a Digital Multi-? Pressing SYSTEM MENU while the menu bar is displayed
channel decoder.will clear the menu bar from the screen.
� To see the selected audio format of the current DVD in the? The selected item will be highlighted, and the appropriate
Status Window, press SYSTEM MENU or Audio.cursor keys to operate it will be displayed below the icon.
? The symbols < or > indicates that more items are available
at the left/right of the menu bar. Press 1 or 2 to select
NTSC/PAL Settingsthese items.
You can switch the NTSC/PAL setting of the DVD player to
match the video signal of your TV. This setting only affects
the televisionOs on-screen display that shows the stop and
setup modes. You may select either NTSC or PAL. To
change the DVD player setting to PAL or NTSC, follow the
steps below.
1Press the POWER ON/OFF button on the front panel of
the DVD player to turn OFF the DVD player.
2Press and hold 9 and T on the front of the DVD player.
While holding 9 and T press POWER ON/OFF.
3After PAL or NTSC appears on the display panel of the
DVD player, release 9 and T at the same time. The PAL
or NTSC indicator that appears on the display panel
indicates the current setting.
4To change the setting, press T within three seconds. The
new setting (PAL or NTSC) will appear on the display
panel.
PREPARATION9 |
ACEC
