8 General Information
Putting Batteries in the Remote Control
1
Remove the battery compartment lid on the back of the remote
control by pressing in the tab, then lifting off the lid.
2
Place two AA batteries inside the battery compartment with
their + and � ends aligned as indicated. Do not mix old and new bat-
teries or different types of batteries (standard, alkaline, etc.).
3
Replace the battery compartment lid.
Package ContentsThree-strand Audio/Video
DVD Playercable (red, white, yellow)
Remote control AC power cord
with two AA batteriesOwnerOs manual
S-Video cable (black)
Using the Remote Control
Unless stated otherwise, the remote control can perform all opera-
tions. Always point the remote control directly at the remote sensor
on the front of the DVD Player, not the TV. Details are on page 20.
Make sure there are no barriers between the remote control and the
DVD Player.
Environmental Information
Your system consists of materials that can be recycled and reused if
disassembled by a specialized company. Please observe the local regula-
tions regarding the disposal of packaging materials, exhausted batteries
and old equipment.
Safety Information
Do not expose the system to excessive moisture, rain, sand, or
heat sources.
Place the DVD Player on a firm, flat surface.
Keep the DVD Player away from domestic heating equipment and
direct sunlight.
When placing the DVD Player in a cabinet, allow about one inch of
space all around the DVD Player for ventilation.
Cleaning Discs
When a Disc becomes dirty, clean it with a cleaning cloth. Wipe
the Disc from the center out, in a straight line.
Do not use solvents such as benzine, thinner, commercially available
cleaners, or anti-static spray intended for analog discs.
If the DVD Player cannot read Discs correctly, use a commonly
available cleaning CD/DVD to clean the lens. Other cleaning meth-
ods may destroy the lens. Always keep the tray closed to avoid
dust on the lens.
The lens may cloud over if you suddenly move the DVD Player
from cold to warm surroundings. Playing a Disc is not possible
then. Leave the power on for about one hour with no Disc in the
unit until normal playback is possible. |
ACEC
