14 Hookups (contOd)
Connecting to a TV and a Stereo Receiver
TM
(Receiver has Dolby Digital, MPEG2, or Digital Theater System)
S-AUDIO IN
Back of TV
(example only)
Stereo Receiver
Antenna
or Cable TVCOAXIAL DIGITAL(example only)
SignalS-VIDEO INAUDIO IN
2
4
3
EXT 3EXT 3
COMPONENT VIDEOPROG
SCAN
YYY
LL
PBPBPBL
PRPRPRR
RR
IN
RC 6
EXT 2EXT 1EXT 1/2
1
Connect your Antenna or Cable TV signal to the ANTENNA jack
on the rear of the DVD Recorder.
1Helpful Hints
Connect one of the DVD RecorderOs DIGITAL AUDIO OUT jacks
Y Set the Digital output accordingly.
(COAX (coaxial) or OPTICAL) to the corresponding DIGITAL
2Details are on page 56.
AUDIO IN jack on your Stereo. You only need one connection. Use an
Y If your Digital Output setting does
appropriate digital audio cable (not supplied).
not match your StereoOs capabili-
ties, the Stereo may produce a
Connect the supplied S-Video cable to the S-VIDEO OUT (Y/C)
strong, distorted sound or no
(EXT 1) jack of the DVD Recorder and to the TVOs
3sound at all.
S-VIDEO IN jack.
Y Your Stereo must support
MPEG2, Dolby DigitalTMor Digital
Connect the supplied power cord to the MAINS (AC Power) jack
Theater System (DTS). Check the
on the rear of the DVD Recorder.
4StereoOs manual.
Connect the power cords of the DVD Recorder, Stereo, and TV to
Y To use the VIDEOOUT (CVBS)
a power outlet.
or COMPONENT VIDEO OUTY
PBPRjacks instead, see pages 10
Turn on the Stereo power and set your Stereo to the correct
and 12. Remember to choose the
Digital Audio In channel or sound source. Refer to the Stereo ownerOs
5correct Video In channel at the
manual.
TV.
Y A small, square, black cap pro-
Press the STANDBY-ON yy button on the front of the DVD
tects the OPTICAL jack when it is
Recorder to turn on the DVD Recorder. The STANDBY-ON light will
6not in use. Remove the cap if you
turn green.
want to use the jack; replace the
If OTURN ON TV� appears on the display panel, you need to turn on your
cap when the jack is not in use.
TV and set it to the correct S-Video In channel. (See next step.) This is part
Y If you plan to watch your TV with
of the Initial Setup of the DVD Recorder. You cannot see the Initial Setup
the DVD Recorder off, connect
screens until you turn on the TV and have it on the right S-Video In channel.
the supplied RF coaxial cable to
the RecorderOs TV jack and to the
Turn on the TV power. Set the TV to the correct S-Video In chan-
RF IN or ANTENNA IN jack (75
nel. This is not channel 3 or 4 as it might be when using a VCR. See your TV
7ohm) on your television. This lets
ownerOs manual for details. Or, go to your lowest TV channel and change
you watch channels at the TV
channels down until you see the DVD background picture or Initial Setup
normally when the DVD Recorder
screen on the TV screen.
is off and will improve the recep-
The Initial Setup screen will appear the first time you turn on the Recorder. Go to
tion at your TV.
page 16 to continue. |
ACEC
